Dell Precision 350: AGP Card
AGP Card: Dell Precision 350
Back to Contents Page
AGP Card
DellPrecision™Workstation350ServiceManual
Removing an AGP Card
1. Some AGP cards require a power cable. If the card has a power cable attached to it, disconnect the cable from the card.
2. Remove the filler bracket by raising the hinged lever and sliding the bracket up.
3. Press the card lever toward the PCI connector.
4. Pull the card up and out of the card clip.
Installing an AGP/Card
1. To add or replace the card, press the card lever toward the PCI connector and gently press the card into the AGP connector until it clicks into place.
2. Release the card lever, ensuring that the tab fits into the notch on the front end of the card.
3. Secure the card by lowering the hinged lever on the back panel.
4. If you disconnected a power cable from the card in step1 of the previous procedure, reconnect the cable to the card.
5. Close the computer cover.
6. Connect the monitor cable to the card's video connector.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
1
hinged lever
2
filler bracket
1
notch
4
card clip
2
lever
5
AGP connector
3
tab
6
PCI connector
7. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
