Главная > Компьютеры > Dell > Precision 350

Dell Precision 350: инструкция

Раздел: Бытовая, кухонная техника, электроника и оборудование

Тип: Компьютер

Инструкция к Компьютеру Dell Precision 350

DellPrecision™Workstation350ServiceManual

Notes, Notices, and Cautions

Information in this document is subject to change without notice.

©2003DellComputerCorporation.Allrightsreserved.

Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden.

Trademarks used in this text: Dell, the DELL logo, and Dell Precision are trademarks of Dell Computer Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Computer Corporation

disclaims any proprietary interest in trademarks and trade names other than its own.

March 2003 Rev. A01

Before You Begin

Opening the Computer Cover

Memory

Drives

PCI Cards

AGP Card

Microprocessor

I/O Panel

Control Panel

Chassis Intrusion Switch

Battery

Power Supply

System Board

Closing the Computer Cover

NOTE: A NOTE indicates important information that helps you make better use of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.

Back to Contents Page

Battery

DellPrecision™Workstation350ServiceManual



Replacing the Battery

A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.

The battery may need replacing if you have repeatedly reset the time and date information after turning on the computer or if one of the following messages

appear:

Time-of-day not set - please run SETUP program

or

Invalid configuration information -

please run SETUP program

or

Strike the F1 key to continue,

F2 to run the setup utility

To determine whether you need to replace the battery, reenter the time and date in system setup and exit the program to save the information. Turn off your

computer and disconnect it from the electrical outlet for a few hours; then reconnect the computer, turn it on, and enter system setup. If the date and time are

not correct in system setup, replace the battery.

You can operate your computer without a battery; however, without a battery, the configuration information is erased if the computer is turned off or

unplugged from the electrical outlet. In this case, you must enter system setup and reset the configuration options.



To replace the battery:



1. Shut down the computer through the Start menu.

2. Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut

down your computer, turn them off now.



3. Disconnect any telephone or telecommunication lines from the computer.

4. Disconnect your computer and all attached devices from electrical outlets, and then press the power button to ground the system board.

5. If you have installed a padlock through the padlock ring on the back panel, remove the padlock.



6. Open the computer cover.

7. Locate the battery socket labeled BATTERY.



8. Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver.

9. Insert the new battery into the socket with the side labeled "+" facing up, and snap the battery into place.



CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.

CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the

manufacturer. Discard used batteries according to the manufacturer's instructions.

NOTE: If you have not already done so, make a copy of your configuration information, found in system setup.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the

computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.

NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is

inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off

the socket or by breaking circuit traces on the system board.