Pioneer S-71W: CONNECTIONS LINE LEVEL CONNECTION SPECIFICATIONS CONNECTING THE POWER CORD OPERATION

S-71W_XRC3473A@en.fm 7 ページ ２００９年９月１１日　金曜日　午後４時４８分

• If the unit’s power cord is connected to a

CONNECTIONS

switched AC outlet on the amplifier or

receiver and the switch is left ON, the

Before making or changing any

unit can be turned ON/OFF together with

connections, switch off the power and

the amplifier or receiver.

disconnect both this unit and the

• If the unit cannot be connected to the

amplifier/receiver from the AC outlet.

amplifier or receiver, turn the power to

LINE LEVEL CONNECTION

the amplifier or receiver ON before

Rear Panel Supplied RCA plug cord

turning the power to the unit ON. When

turning the power OFF, turn the power to

the unit OFF before turning the power to

the amplifier or receiver OFF.

2. Operate the amplifier or receiver and

adjust the volume of the other

speakers.

3. Adjust the volume of the bass with the

VOLUME knob (3).

• When necessary, operate the PHASE

switch (5) and then adjust with the

VOLUME knob (3).

Connect the set’s LINE IN terminal to the

4. Turn the POWER switch (2) OFF.

amplifier or receiver’s SUBWOOFER PREOUT

• The power indicator disappears.

terminal using the included RCA pin cord.

CAUTION:

NOTE:

• Do not use the speaker to output distorted

• When connected to the PREOUT terminal

sound for long periods of time. This can

for surround center channel on the

result in damages to the speaker and poses

amplifier or receiver, the bass is heard only

a potential fire hazard.

on the center channel, so it will be

insufficient.

SPECIFICATIONS

Cabinet............................... Bass-reflex, floor type

CONNECTING THE POWER

Speaker .......................................25 cm cone type

CORD

Power Amplifier Continuous Power Output

(RMS) ..................................... 160 W/6 Ω (100 Hz)

Input (sensitivity at 100 Hz)

LINE LEVEL (RCA jack)........................... 190 mV

Outline Dimension

............ 372 mm (W) x 394 mm (H) x 412 mm (D)

Weight (without package) .........................19.3 kg

Power cord

Power Requirements

................................220 V to 240 V~, 50 Hz/60 Hz

Power Consumption ................................... 130 W

Power consumption in standby .........0.45 W less

Connect the power cord for this unit to the

unit’s power connector (AC IN), and the other

Specifications and design subject to possible

ends to an AC power supply. When turning on

modification without notice, due to

the power, turn on the power to the amplifier

improvements.

first, then the power to this unit.

Published by Pioneer Corporation.

OPERATION

Copyright © 2009 Pioneer Corporation.

For details regarding operating part functions,

All rights reserved.

refer to PANEL FACILITIES on page 6.

1. Turn the POWER switch (2) ON.

7

En