Pioneer CP-ST100: 5 Assemble the arm and support (short) and pass each speaker wire through in order as shown. Caution

CP-ST100_EN.book 4 ページ ２００８年７月１７日　木曜日　午前１０時８分

5 Assemble the arm and support (short) and pass each

Assemble the stands so that the screw holes in the supports

speaker wire through in order as shown.

are all oriented toward the rear side of the stand, then insert

the furnished countersunk screws and tighten securely.

• The arms are designed with specific up-down orientation;

confirm that the side with the wire clip is oriented downward

during assembly.

Pass the appropriate speaker wire through each arm and

mount the assembled arms in order on the long support. In

the case of the speaker wire for the lowest arm, do not pass

the wire through the arm, but allow the wire to exit the

cutaway portion of the arm as shown, then affix a cap to the

top of the arm.

Caution

• Do not attempt to insert

• Do not attempt to use more

screws when the supports

than three arms on a single

holes are oriented at a

stand, since the stand may

diagonal angle from the

fall and cause damage or

rear of the stand.

injuries.

Place cap on top of uppermost arm.

6 Decide on the directional orientation for each

speaker, then fix in place with the furnished

countersunk screws.

• Each arm can mounted facing forward, or pointing 60° to

right or left. If a lower speaker unit has an upward-pointing

speaker, orient its direction away from the speaker above it.

When fixing the speakers in place, also consult the section

“Assembly Hints” on page 2.

Examples of stand with mounted speakers

4

En