Pioneer S-3EX-QL: Other Information Attaching/Removing the Grille Cover Specifications Cleaning the speaker cabinet

Other Information Attaching/Removing the Grille Cover Specifications Cleaning the speaker cabinet: Pioneer S-3EX-QL

S-3EX_EN.book 11 ページ 2007年4月23日 月曜日 午後5時12分

Other Information

Attaching/Removing the Grille Cover

Specifications

This speaker system comes with grille covers which may be

Enclosure. . . . . . . . . . . . . . . . . . . . . . . . . Bass-reflex floorstanding type

English

attached and removed by:

(magnetically shielded)

Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-way

1 To attach the grille cover, line up the holes on the speaker

Woofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 cm cone x2

with the inserts on the grill, and press firmly.

Mid tweeter . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 cm cone / 3 cm dome

Nominal impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

2 To remove the grille cover, grab it by its bottom with

Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Hz to 100 kHz

both hands and gently pull toward you to separate the

Sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88.5 dB (2.83 V)

bottom part of the grille from the speaker.

Maximum input power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160 W

3 Slide your hands up to the middle section of the grille,

Exterior dimensions . . . . . . 350 (W) mm x 1224 (H) mm x 541 (D) mm

and once again pull gently toward you. This will remove the

Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 kg

middle section of the grille from the speaker.

Supplied accessories

4 Finally, repeat this same motion for the top part of the

Spike bases . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

grille, removing the grille entirely from the speaker.

Mounting pads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 types, 2 each

Metal catch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Screw (for metal catch) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Grille . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Operating instructions

Specifications and design subject to possible modification

without notice, due to improvements.

Magnetic shielding

This speaker system is magnetically shielded. However,

depending on the installation location, color distortion may occur

if the speaker system is installed extremely close to the screen of

a television set.

If this happens, turn off the television, then turn it on again after

15 min to 30 min. If the problem persists, place the speaker system

away from the television set.

is a trademark placed on a product with Pioneer’s Phase

Control technology. This technology enables high-grade sound

Cleaning the speaker cabinet

reproduction through each component by improving overall

phase matching.

With normal use, wiping with a dry cloth should be sufficient to

keep the cabinet clean. If necessary, clean with a cloth dipped in

a neutral cleanser diluted five or six times with water, and wrung

out well. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals

on or near this unit since these will corrode the surfaces.

Published by Pioneer Corporation.

Copyright © 2007 Pioneer Corporation.

All rights reserved.

11

En