Pioneer S-3EX-QL: Installation and Placement How to install

S-3EX_EN.book 6 ページ ２００７年４月２３日　月曜日　午後５時１２分

Installation and Placement

Mounting the Fall-Prevention Fastener

How to install

• Using the included screw, tightly secure the metal catch to the

backside of the speaker.

This speaker system is supported by three points (the front two

legs, and the back spike located between the back two legs).

Front

Nut (for spike)

• Pass a commercially-available reinforced string through the

metal catch to securely support the speaker to the wall. Be

sure that the wall to which you fasten the speaker is strong

Cabinet base

enough to support the weight of the speaker. After fastening

the speaker, make sure that it does not fall over.

• The speaker can incur damage in the event of a fall.

Back

Back spike

• Do not attach the metal catch directly to the wall. It should

only be used in conjunction with reinforced string to prevent

Legs

the speaker from falling.

1 Choose the location for speaker placement then put the

spike bases on the floor.

Metal catch

2 Place the speaker on top of the spike bases.

Sufficiently thick cord

3 If either the left or right back legs touches the ground

before the back spike, resulting in the speaker not resting

Backside of speaker

flat on its placed surface, adjust the back spike so it extends

• Pass two reinforced strings through the metal catch, and

to the ground before either of the back legs.

fasten the speaker to the wall as shown above.

4 Place the included mounting pads underneath the back

legs to keep the speaker stable.

Do not place the speaker where it will be in direct

Choose the most appropriate thickness of mounting pad from the

sunlight, and avoid positioning it near heaters and air

several types included.

conditioners. Doing so may cause warping and

discoloration of the speaker cabinet and damage to

the speaker.

Pioneer assumes no liability whatsoever for

damages resulting from assembly, improper

mounting, insufficient reinforcement, misuse of the

product, acts of nature, etc.

Mounting pad

• Do not place the speaker on an unstable surface. It could present a hazard if it falls, as well as damaging the equipment.

• As a precautionary measure, be sure to not place the unit anywhere where it might fall on a sleeping individual in the event of an

earthquake.

• As this unit weighs some 48 kg, it is very dangerous to try and set the spike nut while tilting the speaker. Be sure to place the unit on a

soft area (such as a blanket) so that it does not damage the floor, and carry out the installation with at least two people.

6

En