Pioneer HTP-SLH600: Wall mounting the speakers

• When installing, allow at least 10 cm space between the rear

of the unit and any wall; when installing vertically, also allow

at least 10 cm space between the unit's left side and any wall.

• Mounting the speakers in an unstable location is extremely

If insufficient distance is taken, the unit may display

dangerous and should not be attempted.

inadequate performance, or may malfunction.

• Do not install the speakers on top of a television set or other

• Since the speaker system is heavy, installation in unstable

unstable location. The speakers may fall, causing damage or

locations is extremely dangerous and should not be

personal injury.

attempted. A falling speaker may cause damage or personal

S-HV500-LR

injury.

• Sounds played through speaker systems are easily affected in

subtle ways by the conditions in the listening space.

• Can be mounted vertically or horizontally.

Wall mounting the speakers

• When using a thin-profile television, place the speakers to the

(S-HV600B/S-HV500-LR)

sides of the television, separated from the television by 5 cm

or more.

• When using a CRT television, separate the speakers from the

Before mounting

television by 10 cm. Since these speakers are designed for

• Remember that the speaker system is heavy and that its

low-magnetic-flux leakage, some color smearing may be

weight could cause the screws to work loose, or the wall

experienced depending on the installation conditions. In this

material to fail to support it, resulting in the speaker falling.

case, turn off the power to the television and wait for 15

Make sure that the wall you intend to mount the speakers on

minutes to 30 minutes. If color smearing continues, separate

is strong enough to support them. Do not mount on plywood

the speaker systems farther from the television.

or soft surface walls.

• If the room has a lot of reverberation, we recommend hanging

• Mounting screws are not supplied. Use screws suitable for the

heavy fabric on the walls, and/or putting a carpet on the floor

wall material and support the weight of the speaker.

to damp the sound. For best results, cover walls completely.

• If you are unsure of the qualities and strength of the wall,

• Mounting the speakers in an unstable location is extremely

consult a professional for advice.

dangerous and should not be attempted.

• Pioneer is not responsible for any accidents or damage that

• Do not install the speakers on top of a television set or other

result from improper installation.

unstable location. The speakers may fall, causing damage or

S-HV600B

personal injury.

1 Use a Phillips screwdriver to remove the two screws

S-SLW500

holding the stands to the speaker.

• The subwoofer reproduces ultra-low sounds in monaural,

using the fact that the human ear has little directional

sensitivity to sounds in the low frequencies. As a result, the

subwoofer can be located in a variety of places, but if placed

too distant, the linkage between sounds of the subwoofer and

other speakers may seem unnatural. The intensity of the

sound from the subwoofer can be adjusted by changing the

distance from the wall.

• Front speakers installed to the right and left should be

separated by about 1.8 m to 2.7 m distance. They should be

2 Using the two screws removed in step 1, fasten the wall

installed at equal distances from the television, and at equal

mounting fixtures to the speaker.

heights from the floor.

• Optional speaker stands can be purchased to facilitate

optimal mounting of the surround speakers at or slightly

above the listener’s ear height.

• The surround effect will be diminished if the surround

speakers are mounted at extreme distances from the listener’s

position.

• The subwoofer is not magnetically shielded and so should not

be placed near a TV or monitor, as the interaction of magnetic

materials can cause distortion of the colors on your TV screen.

Devices easily affected by magnetism (magnetic media cards,

wrist-watches, video tapes, etc.) should not be placed near the

3 Affix the supplied wire stays to the top of the unit as

subwoofer.

shown and collect the cable there.

• When installing the speaker system on a TV rack or AV rack,

the rack or other audio components may vibrate due to

vibrations generated by the speaker. Caution should be taken

to assure that the rack shelves or other components do not

shift positions due to the vibration.

• Do not place disc media (DVD, CD) players on top of the

subwoofer since sound skipping may occur due to vibration.

6

En

S-HV600B_S-HV500-LR_En.fm 6 ページ ２０１１年４月１２日　火曜日　午後２時３１分