Pioneer DEH-140UBB: Installation Power amp (sold separately) DIN front/rear mount

3 Antenna input

4 Fuse (10 A)

5 Wired remote input

Hard-wired remote control adaptor can be

connected (sold separately).

Power cord

3

4

1

2

5

6

3

4

7

5

6

8

a

9

b

e

8 Black (chassis ground)

1 System remote control

! When installing, to ensure proper heat dis-

9 Blue/white

Connect to Blue/white cable.

persal when using this unit, make sure you

The pin position of the ISO connector will dif-

2 Power amp (sold separately)

leave ample space behind the rear panel and

fer depending on the type of vehicle. Connect

3 Connect with RCA cables (sold separately)

wrap any loose cables so they are not block-

9 and b when Pin 5 is an antenna control

4 To Rear output

ing the vents.

type. In another type of vehicle, never con-

5 Rear speaker

nect 9 and b.

a Blue/white

Connect to system control terminal of the

Installation

power amp (max. 300 mA 12 V DC).

Important

b Blue/white

! Check all connections and systems before

Connect to auto-antenna relay control termi-

final installation.

nal (max. 300 mA 12 V DC).

! Do not use unauthorized parts as this may

c Yellow/black

cause malfunctions.

Only for DEH-142UB, DEH-140UB and DEH-

! Consult your dealer if installation requires

140UBB.

drilling of holes or other modifications to the

If you use an equipment with Mute function,

vehicle.

wire this lead to the Audio Mute lead on that

! Do not install this unit where:

equipment. If not, keep the Audio Mute lead

— it may interfere with operation of the vehicle.

free of any connections.

— it may cause injury to a passenger as a result

d Speaker leads

of a sudden stop.

White: Front left +

! The semiconductor laser will be damaged if

White/black: Front left *

it overheats. Install this unit away from hot

c

Gray: Front right +

places such as near the heater outlet.

Gray/black: Front right *

! Optimum performance is obtained when the

Green: Rear left +

unit is installed at an angle of less than 60°.

Green/black: Rear left *

1 To power cord input

Violet: Rear right +

2 Depending on the kind of vehicle, the func-

Violet/black: Rear right *

60°

tion of 3 and 5 may be different. In this

e ISO connector

case, be sure to connect 4 to 5 and 6 to

In some vehicles, the ISO connector may be

3.

divided into two. In this case, be sure to con-

3 Yellow

nect to both connectors.

Back-up (or accessory)

4 Yellow

Power amp (sold separately)

Connect to the constant 12 V supply termi-

Perform these connections when using the op-

nal.

tional amplifier.

5 Red

Accessory (or back-up)

1

3

6 Red

2

Connect to terminal controlled by ignition

4





switch (12 V DC).

55





7 Connect leads of the same color to each

other.

Section

03

Installation

Installation

Leave ample

5 cm

space

5 cm

DIN front/rear mount

This unit can be properly installed using either

front-mount or rear-mount installation.

Use commercially available parts when instal-

ling.

DIN Front-mount

1 Insert the mounting sleeve into the dash-

board.

For installation in shallow spaces, use the sup-

plied mounting sleeve. If there is enough space,

use the mounting sleeve that came with the ve-

hicle.

2 Secure the mounting sleeve by using a

screwdriver to bend the metal tabs (90°) into

place.

1

2

1 Dashboard

8

En