Pioneer CP-81B-MK: Attaching speakers to the stands

When using the spikes

This speaker stand includes spikes that you can use to isolate the

Attaching speakers to the stands

speaker from the floor. Spikes are recommended when placing

A medium Phillips screwdriver is required for assembling the

the stand on a thick carpet (for added stability), or for better sound

speaker stand and for attaching the speaker.

when placing the stand on a hard reverberant surface (such as a

concrete or wood floor). Use the supplied spike bases to avoid

Assembling the speaker stands

scratching the floor or other surface where the stand is placed.

English

Assemble the speaker stands as illustrated below.

Align the screw holes on the stand base and speaker support

with the screw holes in the three stems, then insert the

screws and tighten.

1 Twist the spikes into the threaded metal inserts

embedded in the bottom of the stand base.

2 Set the spike bases in the positions where the points of

the three spikes will strike when the speaker stand is set

down.

3 Set the speaker stand on the spike bases and check to

confirm the speaker stand does not rock.

• Note that these spikes are sharp metal and can cause damage

to flooring. Make sure to lay down a cloth or suitable base

before setting up.

• Always use the spike bases as shown, with the indented

surface facing up to receive the spike point.

• Make sure you assemble the stand on a flat surface that is

relatively soft (such as a carpet).

• Make sure the screws are inserted in the screw holes as

shown above (with the screw head hidden) when securing the

speaker. Improper setup could result in damage or injury if the

speaker falls from the stand.

When using the non-skid pads

3

En

If you do not use the spike bases when placing the

speakers, the spikes may cause damage to the floor. If

you plan on using the spikes we highly recommend to

use the spike bases.

FRRD-235-A_CP-81_En.book 3 ページ ２００８年７月２４日　木曜日　午後２時１５分