Pioneer CP-7EX: Using the spikes Attaching a speaker to the stand Cabinet and stand maintenance

Using the spikes

Attaching a speaker to the stand

The speaker stand includes spikes that you can use to isolate

To avoid accident or injury, please use screws to secure the

the speaker from the floor. Spikes are recommended when

speaker to the speaker stand. Note that there are fastening

placing the stand on a thick carpet (for added stability), or for

English

nuts provided on the speaker base (see below). Secure the

better sound when placing the stand on a hard reverberant

speaker to the speaker support using the washer, spring

surface (such as a concrete or wood floor). Use the supplied

washer and the 60 mm screws as shown below.

spike bases to avoid scratching the floor or other surface

where the stand is placed.

Stand base plate

Fastening nuts

Speaker

base

Screw slots

1

Spike

for securing

speaker

Speaker

support

2

Nut

Washers (SBE6008)

Spring washer

60 mm

(SBE6007)

Black

Screws

1 Attach the spikes to the nuts provided.

(Bind head, M6xL60)

(SBA6058)

2 Attach all four spikes to the threaded metal inserts

at the base of the speaker stand.

3 Choose the location for speaker placement then put

the spike bases on the floor.

Cabinet and stand maintenance

• Use a polishing cloth or dry cloth to wipe off dust and

4 Place the stand so that the spikes are resting on the

dirt.

spike bases on the floor.

Before placing the speaker on the speaker stand, make sure

• If the cabinet or stand is very dirty, use a soft cloth

the stand is stable and resting squarely on all four spikes.

dipped in some neutral cleanser diluted 5 or 6 times

with water. Finally, wipe again using a dry cloth. Do not

use furniture wax or cleaners.

• Never use thinners, benzine, insecticide sprays and

• Note that these spikes are sharp metal and can cause

other chemicals on or near the cabinet or stand, since

damage to flooring. Make sure to lay down a cloth or

these will corrode the surfaces.

suitable base before setting up.

• The spike bases should be placed as shown below (with

the depression on the top side).

• Make sure to use the spike bases provided to avoid

damaging the surface where you place the stand.

3

En