Pioneer CP-7EX: Assembling the speaker stands Installing the speaker stands

Thank you for buying this Pioneer product. This speaker

Assembling the speaker stands

stand should only be used with the S-7EX Pioneer speaker

Assemble the speaker stands as illustrated below. Please

system. Please read through these operating instructions for

note that a flathead screwdriver will be necessary for

proper assembly and use. After you have finished reading the

assembly. The following illustration shows the fully assem-

instructions, put them away in a safe place for future

bled speaker stand:

reference.

Screw slots

Before you start

Speaker support

for securing

Before setting up your speaker system, we recommend

speaker

reading the operating instructions for your system thor-

oughly.

Stand stems

• Only use the screws supplied when fixing the speaker to

Stand base

the speaker stand.

• Do not place the stand on an unstable and/or sloping

surface. The stand and speaker may fall and cause

injury.

• Align the screw slots on the stand base and screw

• Do not use with any speaker system other than the one

holes on the speaker support with the screw holes in

for which the unit was designed. The stand may collapse

the two stems, then insert the screws and tighten.

and be damaged and/or the speaker may fall and cause

The screw slots allow you to fine-tune the positioning of the

injury.

speaker.

• When moving the speaker and stand, first remove the

speaker from the stand, and then move the stand,

holding it by the two stems.

Screws (Bind head, M6xL55)

Installing the speaker stands

Place the stand on a stable, level surface; placing the stand

55 mm

on an unstable surface can be dangerous.

Speaker

Black

support

(SBA6051)

Stand

Please note that sunken

stems

screw holes are provided

in the speaker support.

Stand

base

Adjust the position as necessary to obtain optimal sound

from your system.

Screws (Bind head, M6xL40)

Nut

Spike

(SBA6053)

• Pioneer assumes no liability whatsoever for damages

40 mm

Spike base

resulting from assembly, improper mounting, insuffi-

(SLA1057)

Black

cient reinforcement, misuse of the product, acts of

(SBA6054)

nature, etc.

• Make sure you assemble the stand on a flat surface that

is relatively soft (such as a carpet).

• Make sure the screws are inserted in the screw holes as

shown above (with the screw head hidden) when

securing the speaker. Improper setup could result in

damage or injury if the speaker falls from the stand.

2

En