Pioneer CP-4EX: Attaching speakers to the stands Names of Parts

Thank you for buying this Pioneer product. This speaker stand

should only be used with the S-4EX Pioneer speaker system.

Attaching speakers to the

Please read through these operating instructions for proper

assembly and use. After you have finished reading the

stands

instructions, put them away in a safe place for future reference.

A medium Phillips screwdriver is required for attaching the

speakers.

Before you start

Before setting up your speaker system, we recommend reading

Assembly with the S-4EX speaker

the operating instructions for your system thoroughly.

system

If you are using the S-4EX speaker system, note that there is a

fastening nut provided on the speaker base (see below).

• Do not use this speaker stand with speakers other than the

Pioneer S-4EX, since the product balance may be impaired,

When installing spikes on speaker

resulting in tipping or dangerous falls.

Use only spikes supplied with S-4EX.

• Only use the screws supplied when fixing the speaker to the

speaker stand.

1 Set spikes into three locations on bottom of speaker.

Consult the S-4EX operating instructions for additional

• Do not place the stand on an unstable and/or sloping surface.

instructions.

The stand and speaker may fall and cause injury.

• Do not use with any speaker system other than the one for

2 Apply the furnished cork plates on the three locations on

which the unit was designed. The stand may collapse and be

the speaker support.

damaged and/or the speaker may fall and cause injury.

• When moving the speaker and stand, first remove the speaker

from the stand, and then move the stand, holding it by the

stems.

• Place the stand on a stable, level surface; placing the stand on

an unstable surface can be dangerous.

• Pioneer assumes no liability whatsoever for damages

resulting from assembly, improper mounting, insufficient

3 Rest the speaker gently on the speaker support while

reinforcement, misuse of the product, acts of nature, etc.

aligning the spikes with the cork plates on the top of the

speaker support, then fix in placing using the washers,

spring washers, and screws (bind head M5 x L55).

Names of Parts

2

En

01_CP-4EX_EN.fm 2 ページ ２００８年７月２４日　木曜日　午後１２時５０分

Speaker base

Fastening nut

Screw holes

Cork plates

for securing

speaker

Speaker

support

Washer

[SBE6006]

Spring washer

55 mm

[SBE6005]

Screws

(Bind head, M5 x L55)

Black

[SBA1307]