Asus D452EP: Appendices

This table shows the countries currently under the

CTR21 standard.

Country Applied More Testing

1

Austria

Yes No

Belgium Yes No

Czech Republic No Not Applicable

1

Denmark

Yes Yes

Finland Yes No

France Yes No

Germany Yes No

Greece Yes No

Hungary No Not Applicable

Iceland Yes No

Ireland Yes No

Italy Still Pending Still Pending

Israel No No

Lichtenstein Yes No

Luxemburg Yes No

1

The Netherlands

Yes Yes

Norway Yes No

Poland No Not Applicable

Portugal No Not Applicable

Spain No Not Applicable

Sweden Yes No

Switzerland Yes No

United Kingdom Yes No

This information was copied from CETECOM and is supplied without liability. For

updates to this table, you may visit http://www.cetecom.de/technologies/ctr_21.

html

1 National requirements will apply only if the equipment may use pulse dialling

(manufacturers may state in the user guide that the equipment is only intended to

support DTMF signalling, which would make any additional testing superuous).

In The Netherlands additional testing is required for series connection and caller

ID facilities.

Federal Communications Commission

Interference Statement

This device complies with FCC Rules Part 15. Operation is subject to the following

two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a class

B digital device, pursuant to Part 15 of the Federal Communications Commission

(FCC) rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment o and on, the user

is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

Notebook PC E-Manual

113

• Connect the equipment into an outlet on a circuit dierent from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

WARNING! The use of a shielded-type power cord is required in order to meet

FCC emission limits and to prevent interference to the nearby radio and television

reception. It is essential that only the supplied power cord be used. Use only shielded

cables to connect I/O devices to this equipment. You are cautioned that changes or

modications not expressly approved by the party responsible for compliance could

void your authority to operate the equipment.

(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993.

Washington DC: Oce of the Federal Register, National Archives and Records

Administration, U.S. Government Printing Oce.)

FCC Radio Frequency (RF) Exposure Caution

Statement

WARNING! Any changes or modications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

“The manufacture declares that this device is limited to Channels 1 through 11 in the

2.4GHz frequency by specied rmware controlled in the USA.”

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. To maintain compliance with FCC RF exposure

compliance requirements, please avoid direct contact to the transmitting antenna

during transmitting. End users must follow the specic operating instructions for

satisfying RF exposure compliance.

Declaration of Conformity (R&TTE directive

1999/5/EC)

The following items were completed and are considered relevant and sucient:

• Essential requirements as in [Article 3]

• Protection requirements for health and safety as in [Article 3.1a]

• Testing for electric safety according to [EN 60950]

• Protection requirements for electromagnetic compatibility in [Article 3.1b]

• Testing for electromagnetic compatibility in [EN 301 489-1] & [EN 301

489-17]

• Eective use of the radio spectrum as in [Article 3.2]

• Radio test suites according to [EN 300 328-2]

CE Marking

CE marking for devices without wireless LAN/Bluetooth

The shipped version of this device complies with the requirements of the EEC

directives 2004/108/EC “Electromagnetic compatibility” and 2006/95/EC “Low

voltage directive”.

CE marking for devices with wireless LAN/ Bluetooth

This equipment complies with the requirements of Directive 1999/5/EC of the

European Parliament and Commission from 9 March, 1999 governing Radio and

Telecommunications Equipment and mutual recognition of conformity.

Notebook PC E-Manual

115

IC Radiation Exposure Statement for Canada

This equipment complies with IC radiation exposure limits set forth for an

uncontrolled environment. To maintain compliance with IC RF exposure

compliance requirements, please avoid direct contact to the transmitting antenna

during transmitting. End users must follow the specic operating instructions for

satisfying RF exposure compliance.

Operation is subject to the following two conditions:

• This device may not cause interference and

• This device must accept any interference, including interference that may

cause undesired operation of the device.

To prevent radio interference to the licensed service (i.e. co-channel Mobile

Satellite systems) this device is intended to be operated indoors and away from

windows to provide maximum shielding. Equipment (or its transmit antenna) that

is installed outdoors is subject to licensing.

This device complies with Industry Canada licence-exempt RSS standard(s).

CAN ICES-3(B)/NMB-3(B)

Déclaration d’Industrie Canada relative à l’

exposition aux ondes radio

Cet appareil est conforme aux limites d’exposition aux radiations d’Industrie

Canada dénies pour un environnement non-contrôlé. Pour maintenir la

conformité avec les exigences d’exposition RF d’IC, veuillez éviter tout contact

direct avec l’antenne pendant l’émission. Les utilisateurs naux doivent suivre

les instructions de fonctionnement spéciques pour satisfaire la conformité aux

expositions RF.

Son utilisation est sujette aux deux conditions suivantes :

• Cet appareil ne peut pas causer d’interférence, et

• Cet appareil doit accepter toute interférence, y compris les interférences

qui pourraient causer un fonctionnement non souhaité de l’appareil.

Pour éviter les interférences radio avec le service sous licence (c’est à-dire le

partage de canal avec les systèmes de téléphonie satellite), cet appareil est destiné

à être utilisé en intérieur et loin des fenêtres pour fournir un blindage maximal.

Tout appareil (ou son antenne d’émission) qui est installé en extérieur est sujet à

cette licence.

Le present appareil est conforme aux CNR d’Industrie Canada applicables aux

appareils radio exempts de licence.

CAN ICES-3(B)/NMB-3(B)

Notebook PC E-Manual

117

Wireless Operation Channel for Dierent

Domains

N. America 2.412-2.462 GHz Ch01 through CH11

Japan 2.412-2.484 GHz Ch01 through Ch14

Europe ETSI 2.412-2.472 GHz Ch01 through Ch13

France Restricted Wireless Frequency Bands

Some areas of France have a restricted frequency band. The worst case maximum

authorized power indoors are:

• 10mW for the entire 2.4 GHz band (2400 MHz–2483.5 MHz)

• 100mW for frequencies between 2446.5 MHz and 2483.5 MHz

NOTE: Channels 10 through 13 inclusive operate in the band 2446.6 MHz to 2483.5

MHz.

There are few possibilities for outdoor use: on private property or on the private

property of public persons, use is subject to a preliminary authorization procedure

by the Ministry of Defense, with maximum authorized power of 100mW in the

2446.5–2483.5 MHz band. Use outdoors on public property is not permitted.

In the departments listed below, for the entire 2.4 GHz band:

• Maximum authorized power indoors is 100mW

• Maximum authorized power outdoors is 10mW

Departments in which the use of the 2400–2483.5 MHz band is permitted with an

EIRP of less than 100mW indoors and less than 10mW outdoors:

01 Ain 02 Aisne 03 Allier

05 Hautes Alpes 08 Ardennes 09 Ariège

11 Aude 12 Aveyron 16 Charente

24 Dordogne 25 Doubs 26 Drôme

32 Gers 36 Indre 37 Indre et Loire

41 Loir et Cher 45 Loiret 50 Manche

55 Meuse 58 Nièvre 59 Nord

60 Oise 61 Orne 63 Puy du Dôme

64 Pyrénées Atlantique 66 Pyrénées Orientales 67 Bas Rhin

68 Haut Rhin 70 Haute Saône 71 Saône et Loire

75 Paris 82 Tarn et Garonne 84 Vaucluse

88 Vosges 89 Yonne 90 Territoire de Belfort

94 Val de Marne

This requirement is likely to change over time, allowing you to use your wireless

LAN card in more areas within France. Please check with ART for the latest

information (www.arcep.fr)

NOTE: Your WLAN Card transmits less than 100mW, but more than 10mW.

Notebook PC E-Manual

119

UL Safety Notices

Required for UL 1459 covering telecommunications (telephone) equipment

intended to be electrically connected to a telecommunication network that has an

operating voltage to ground that does not exceed 200V peak, 300V peak-to-peak,

and 105V rms, and installed or used in accordance with the National Electrical

Code (NFPA 70).

When using the Notebook PC modem, basic safety precautions should always be

followed to reduce the risk of re, electric shock, and injury to persons, including

the following:

• DO NOT use the Notebook PC near water, for example, near a bath tub,

wash bowl, kitchen sink or laundry tub, in a wet basement or near a

swimming pool.

• DO NOT use the Notebook PC during an electrical storm. There may be a

remote risk of electric shock from lightning.

• DO NOT use the Notebook PC in the vicinity of a gas leak.

Required for UL 1642 covering primary (nonrechargeable) and secondary

(rechargeable) lithium batteries for use as power sources in products. These

batteries contain metallic lithium, or a lithium alloy, or a lithium ion, and may

consist of a single electrochemical cell or two or more cells connected in series,

parallel, or both, that convert chemical energy into electrical energy by an

irreversible or reversible chemical reaction.

• Do not dispose the Notebook PC battery pack in a re, as they may

explode. Check with local codes for possible special disposal instructions

to reduce the risk of injury to persons due to re or explosion.

• Do not use power adapters or batteries from other devices to reduce the

risk of injury to persons due to re or explosion. Use only UL certied

power adapters or batteries supplied by the manufacturer or authorized

retailers.

Power Safety Requirement

Products with electrical current ratings up to 6A and weighing more than 3Kg

2

must use approved power cords greater than or equal to: H05VV-F, 3G, 0.75mm

or

2

H05VV-F, 2G, 0.75mm

.

TV Notices

Note to CATV System Installer—Cable distribution system should be grounded

(earthed) in accordance with ANSI/NFPA 70, the National Electrical Code (NEC),

in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial

Cable – installation should include bonding the screen of the coaxial cable to the

earth at the building entrance.

REACH

Complying with the REACH (Registration, Evaluation, Authorization, and

Restriction of Chemicals) regulatory framework, we publish the chemical

substances in our products at ASUS REACH website at http://csr.asus.com/english/

REACH.htm.

Macrovision Corporation Product Notice

This product incorporates copyright protection technology that is protected by

method claims of certain U.S.A. patents and other intellectual property rights

owned by Macrovision Corporation and other rights owners. Use of this copyright

protection technology must be authorized by Macrovision Corporation, and

is intended for home and other limited viewing uses only

unless otherwise

authorized by Macrovision Corporation

. Reverse engineering or disassembly is

prohibited.

Prevention of Hearing Loss

To prevent possible hearing damage, do not listen at high volume

levels for long periods.

Notebook PC E-Manual

121

128

Notebook PC E-Manual