Pioneer KURO PDP-S62: 10. Bundling the cables. When using the hung on wall unit:

English

6

10. Bundling the cables.

Follow the steps below to attach a cable clamp.

1 )  Thread the clamp band through the holder and 

bundle the cable(s) in the cable clamp.

2 )  Push and hold the levers then insert the hook into 

an appropriate hole on the rear of the flat screen TV.

3 )  Pull up the clamp band to lock.

�

�

4 )  Confirm that the cable clamp is seated firmly in the 

panel.

 NOTE:

Avoid pinching or creating pressure points when routing 

or bundling cables.

To remove the clamp band, pull and hold the latch to 

release.

To remove the cable clamp, push and hold the levers 

then pull it out from the hole.

�����

�����

�����

 NOTE:

The longer a clamp is in place, the better chance of 

deterioration. An older clamp is more easily damaged

while being removed and may not be reusable.



�����������������������

�������������

�����������

�����������

�����������

When using the hung on  wall unit:

 NOTE:

First lay the flat screen TV on top of a soft sheet etc., then 

attach the speakers.

1.  Attach the speakers to the flat screen 

TV (See procedures 1 to 10 on pages 

3 to 6).

Connect the other cables and power cord to the flat 

screen TV.

2.  Place the flat screen TV on the 

mounting fittings of the hung on 

wall unit.

For details, refer to the operating instructions supplied 

with the hung on wall unit.

Caution

Do not lift up the flat screen TV by the speakers.  

A speakers may come off, so hold it by the bottom.