Yamaha A-S201 Silver: PREPARATION
PREPARATION: Yamaha A-S201 Silver
PREPARATION
CONNECTIONS
Connecting speakers and source components
Make sure to connect L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. If the connections are faulty, no sound will
be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and
lack bass. Refer to the owner’s manual for each of your components.
Make sure to use RCA cables to connect audio components.
CAUTION
• Do not connect this unit or other components to the main power until all connections between components are
complete.
• Do not let bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the
speakers.
Speakers A
LeftRight
DVD player, etc.CD player
Audio
Audio
out
out
GND
Audio
Audio
Audio
Audio
out
out
out
in
Tuner
CD recorder,
LeftRight
etc.
Speakers B
Turntable
y
• The PHONO jacks are designed for connecting a turntable with an MM cartridge.
• Connect your turntable to the GND terminal to reduce noise in the signal. However, for some turntables, you may hear less noise
without the GND connection.
8 En
CONNECTIONS
■ REC jacks
■ Bi-wire connection
• The REC jacks output audio signals of the currently
Bi-wire connection separates the woofer from the
selected input (except when LINE 2 is selected).
combined midrange and tweeter section.
• Volume level, tone control, balance and Pure Direct
A bi-wire compatible speaker has four binding post
settings do not affect the REC jacks.
terminals. These two sets of terminals allow the speaker to
be split into two independent sections. With these
■ Connecting speaker cables
connections, the mid and high frequency drivers are
1 Remove approximately 10 mm of insulation from the
connected to one set of terminals and the low frequency
end of each speaker cable.
driver to another set of terminals.
2 Twist the bare wires of the cable firmly together.
Rear panel
3 Unscrew the knob.
4 Insert one bare wire into the hole in the side of each
Speaker
terminal.
PREPARATION
5 Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (–)
Connect the other speaker to the other set of terminals in
the same way.
■ Connecting via banana plug
Note
(Except for Asia, U.K. and Europe
models)
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
1 Tighten the knob.
2 Insert the banana plug into the end of the
y
corresponding terminal.
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B on the front panel so that both SP A and B light up
on the front panel display.
Banana plug
Connecting power cable
Plug the power cable into an AC wall outlet after all other
connections are complete.
CAUTION
CAUTION
Only for General model:
Before connecting the power cable, make sure you set
Speaker impedance must be set as shown below.
VOLTAGE SELECTOR of this unit according to your
Speaker connection Speaker impedance
local voltage. Improper setting of VOLTAGE SELECTOR
may cause fire and damage to this unit.
SPEAKERS A or
8 Ω or higher
SPEAKERS B
SPEAKERS A and
16 Ω or higher
SPEAKERS B
(except for North
To the AC wall
America model)
outlet with the
power cable
Bi-wiring
8 Ω or higher
English
9 En
Оглавление
- Integrated Amplifier Integrated Amplifier Amplificateur Intégré Amplificateur Intégré
- INTRODUCTION
- PREPARATION
- BASIC OPERATION
- ADVANCED OPERATION
- ADDITIONAL INFORMATION
- INTRODUCTION
- PRÉPARATION
- OPÉRATIONS DE BASE
- OPÉRATIONS AVANCÉES
- INFORMATIONS COMPLÉMENTAIRES
- EINFÜHRUNG
- VORBEREITUNG
- BEDIENUNG DER GRUNDFUNKTIONEN
- ERWEITERTE BEDIENUNG
- ZUSÄTZLICHE INFORMATIONEN
- INTRODUKTION
- FÖRBEREDELSE
- GRUNDLÄGGANDE ANVÄNDNING
- AVANCERAD ANVÄNDNING
- YTTERLIGARE INFORMATION
- INTRODUZIONE
- PREPARATIVI
- FUNZIONAMENTO DI BASE
- FUNZIONAMENTO AVANZATO
- INFORMAZIONI AGGIUNTIVE
- INTRODUCCIÓN
- PREPARACIÓN
- MANEJO BÁSICO
- MANEJO AVANZADO
- INFORMACIÓN ADICIONAL
- INLEIDING
- VOORBEREIDINGEN
- BASISBEDIENING
- GEAVANCEERDE BEDIENING
- AANVULLENDE INFORMATIE
- ВВЕДЕНИЕ
- ПОДГОТОВКА
- ОСНОВНЫЕ ФУНКЦИИ
- ДОПОЛНИТЕЛЬНЫЕ ФУНКЦИИ
- ДОПОЛНИТЕЛЬНАЯ ИНФОРМАЦИЯ