Asus A7N8X: Chapter 3

3.1 Starting up for the first time

1. After making all the connections, replace the system case cover.

2. Be sure that all switches are off.

3. Connect the power cord to the power connector at the back of the

system chassis.

4. Connect the power cord to a power outlet that is equipped with a surge

protector.

5. Turn on the devices in the following order:

a. Monitor

b. External SCSI devices (starting with the last device on the chain)

c. System power (if you are using an ATX power supply, you need to

switch on the power supply as well as press the ATX power switch

on the front of the chassis).

6. After applying power, the power LED on the system front panel case

lights up. For ATX power supplies, the system LED lights up when you

press the ATX power switch. If your monitor complies with “green”

standards or if it has a “power standby” feature, the monitor LED may

light up or switch between orange and green after the system LED

turns on. The system then runs the power-on tests. While the tests are

running, the BIOS beeps or additional messages appear on the

screen. If you do not see anything within 30 seconds from the time you

turned on the power, the system may have failed a power-on test.

Check the jumper settings and connections or call your retailer for

assistance.

Award BIOS Beep Codes

Beep Meaning

One short beep when No error during POST

displaying logo

Long beeps in an endless loop No DRAM installed or detected

One long beep followed by Video card not found or video card

three short beeps memory bad

High frequency beeps when CPU overheated;

system is working System running at a lower frequency

7. At power on, hold down <Delete> to enter BIOS Setup. Follow the

instructions in Chapter 4.

ASUS A7N266-VM motherboard user guide

33