JVC KD-BT1: Maintenance

Setting menu ( : Initial)

Maintenance

Auto Connect

When the unit is turned on, the connection is

established automatically with....

How to clean the connectors

Off: No Bluetooth device.

Frequent detachment will deteriorate the connectors.

Last: The last connected Bluetooth device.

ENGLISH

To minimize this possibility, periodically wipe the

Order: The available registered Bluetooth device

connectors with a cotton swab or cloth moistened with

found at first.

alcohol, being careful not to damage the connectors.

Auto Answer

Only for the device being connected for “Bluetooth

Phone.”

Off: The unit does not answer the calls

automatically. Answer the calls manually.

On: The unit answers the incoming calls

automatically.

Connector

Reject: The unit rejects all incoming calls.

Moisture condensation

Message Info

Moisture may condense on the lens inside the unit in

Only for the device being connected for “Bluetooth

the following cases:

Phone.”

• After starting the heater in the car.

Auto: The unit informs you of the arrival of a

• If it becomes very humid inside the car.

message by ringing and displaying “MSG.”

Should this occur, the unit may malfunction. In this

Manual: The unit does not inform you of the arrival of

case, eject the disc and leave the unit turned on for a

a message.

few hours until the moisture evaporates.

MIC setting

How to handle discs

Only for the device being connected for “Bluetooth

Phone.”

When removing a disc from its

Center holder

Adjust the microphone volume, [Level 01/02/03].

case, press down the center holder

of the case and lift the disc out,

Version

holding it by the edges.

The Bluetooth software and hardware versions are

• Always hold the disc by the edges.

shown.

Do not touch its recording surface.

When storing a disc into its case, gently insert the

disc around the center holder (with the printed surface

facing up).

• Make sure to store discs into the cases after use.

Continued on the next page

41SETTINGS & REFERENCES

EN34-43_KD-BT1_001A_2.indd 41EN34-43_KD-BT1_001A_2.indd 41 2/12/07 12:25:19 PM2/12/07 12:25:19 PM