JVC GR-D340 E: Loading/Unloading A Cassette

MasterPage: Start_Right

G R -D 3 4 0 P A L .b o o k P a g e 1 7 Thursday , Oc to ber 27 , 2005 3:19 PM

GETTING STARTED

EN 17

● Once the cassette holder is closed, it recedes

Loading/Unloading A Cassette

automatically. Wait until it recedes completely

before closing the cassette holder cover.

The camcorder needs to be powered up to load

● When the battery pack’s charge is low, you may

or eject a cassette.

not be able to close the cassette holder cover. Do

Cassette holder

not apply force. Replace the battery pack with a

cover

fully charged one or use AC power before

PUSH

continuing.

OPEN/EJECT

3 Close the cassette holder cover firmly until it

locks into place.

To protect valuable recordings

Slide the erase protection tab on the back of the

tape in the direction of “SAVE”. This prevents the

tape from being recorded over. To record on this

tape, slide the tab back to “REC” before loading

it.

Erase

Cassette holder

protection tab

NOTES:

Make sure the window side

● If you wait a few seconds and the cassette holder

is facing out.

GETTING STARTED

does not open, close the cassette holder cover

and try again. If the cassette holder still does not

1 Slide and hold OPEN/EJECT in the direction

open, turn the camcorder off then on again.

of the arrow, then pull the cassette holder cover

● If the tape does not load properly, open the

open until it locks. The cassette holder opens

cassette holder cover fully and remove the

automatically.

cassette. A few minutes later, insert it again.

● Do not touch internal components.

● When the camcorder is suddenly moved from a

cold place to a warm environment, wait a short

2 Insert or remove a tape and press “PUSH” to

time before opening the cassette holder cover.

close the cassette holder.

● Be sure to press only the section labelled “PUSH”

to close the cassette holder; touching other parts

may cause your finger to get caught in the

cassette holder, resulting in injury or product

damage.