Sony STR-SE501: Preset Tuning Presetting radio stations Automatic Tuning

40

GB

Receiving Br

oadcasts

Preset Tuning

For details on the buttons used in this section, see “Brief

descriptions of buttons used to receive broadcasts” on

page 38.

Before tuning to preset stations, be sure to preset them by

performing steps on “Presetting radio stations” below.

Presetting radio stations

1

Press TUNER.

The last received station is tuned in.

2

Tune in the station that you want to preset using

Direct Tuning (page 39)‚ or Automatic Tuning (this

page).

3

Press MEMORY.

“MEMORY” appears in the display for a few seconds.

Do Steps 4 to 6 before “MEMORY” goes out.

4

Press SHIFT to select a memory page (A, B or C).

Each time you press SHIFT, the letter “A,” “B” or “C”

appears in the display.

5

Select a preset number by pressing PRESET/PTY

SELECT + or PRESET/PTY SELECT –.

If “MEMORY” goes out before you press the preset

number, start again from Step 3.

6

Press MEMORY again to store the station.

If “MEMORY” goes out before you can store the

station, start again from Step 3.

7

Repeat Steps 2 to 6 to preset another station.

To change a preset number to another station

Do Steps 1 to 6 to preset the new station to the number.

Note

If the AC power cord is disconnected for about two weeks, all the

preset stations will be cleared from the receiver’s memory, and

you will have to preset the stations again.

Automatic Tuning

For details on the buttons used in this section, see “Brief

descriptions of buttons used to receive broadcasts” on

page 38.

1

Press TUNER.

The last received station is tuned in.

2

Press FM/AM to select the FM or AM band.

3

Press TUNING + or TUNING –.

Press the + button to scan from low to high; press the –

button to scan from high to low.

When the receiver reaches either end of the

band

Scanning is repeated in the same direction.

The receiver stops scanning whenever a station is

received.

4

To continue scanning, press TUNING + or TUNING –

again.