JVC KD-SHX751: ~ Turn on the power. ⁄ Adjust the volume.
~ Turn on the power. ⁄ Adjust the volume.: JVC KD-SHX751
Getting started
Basic operations
SOURCE
ENGLISH
BACK
BAND
~ Turn on the power.
⁄ Adjust the volume.
SOURCE
Ÿ
@ Adjust the sound as you want.
You cannot select some sources if they
(See pages 25 – 30.)
are not ready.
! • For FM/AM tuner
To drop the volume in a moment (ATT)
BACK
BAND
To restore the sound,
press it again.
• For DAB tuner
To turn off the power
BACK
BAND
8
EN08-12_KD-SHX751[EY]f.indd 8EN08-12_KD-SHX751[EY]f.indd 8 05.2.15 8:14:36 PM05.2.15 8:14:36 PM
Canceling the display
Setting the clock
demonstration
1 Enter the PSM menu (see page
5).
ENGLISH
If no operations are done for about 45 seconds,
display demonstration starts.
2 Set the hour, minute, and clock
[Initial: Demo]—see page 36.
system.
1 Enter the PSM menu (see page
5).
2 Select “Off.”
1 Select “Clock Hr” (hour), then
• Make sure “Demo/Link” is shown on the
adjust the hour.
display. If not, press 5 or ∞.
2 Select “Clock Min” (minute), then
adjust the minute.
3 Finish the procedure.
3 Select “24H/12H,” then select
“24H” or “12H.”
To activate the display demonstration
3 Finish the procedure.
In step 2 above, select “Demo” or
“ImageLink.” For more details, see page 36.
9
EN08-12_KD-SHX751[EY]f.indd 9EN08-12_KD-SHX751[EY]f.indd 9 05.2.15 8:14:37 PM05.2.15 8:14:37 PM
Оглавление
- KD-SHX751
- ~ Turn on the power. ⁄ Adjust the volume.
- ~
- ! Select a PTY code.
- ~
- Ÿ
- ! Attach the control panel.
- ! Adjust the effect level (1 – 3).
- ! Select the picture size—“Large”
- Ÿ Turn on the connected component
- ~ ! Start searching for an ensemble.
- ~ Das Gerät einschalten. ⁄ Stellen Sie die Lautstärke ein.
- ~
- ! Wählen Sie einen PTY-Code.
- ~
- Ÿ
- ! Anbringen des Bedienfelds.
- ! Passen Sie die Effektstufe an
- !
- Ÿ Schalten Sie die angeschlossene
- ~ ! Starten Sie die Suche nach einem
- ~ Включение питания. ⁄ Настройка громкости.
- ~
- ! Выберите код PTY.
- ~
- Ÿ
- ! Подключите панель управления.
- ! Настройте уровень эффекта
- Ÿ Войдите в меню PICT (см. стр. 5).
- Ÿ Включите подключенное
- ~ ! Запустите поиск блока