Beurer LB 12: ENGLISH

ENGLISH: Beurer LB 12

ENGLISH

Dear Customer,

Thank you for choosing one of our products. Our name stands for high-quality, thoroughly tested

products for applications in the areas of heat, weight, blood pressure, body temperature, pulse, gentle

therapy, massage and air.

Please read these instructions for use carefully and keep them for later use, be sure to make them ac-

cessible to other users and observe the notes they contain.

With kind regards

Your Beurer team

Included in delivery

Air humidifier with removable top and mist outlet

Mains adapter

2 adapters for standard water bottles

Cleaning brush

Storage pouch

These instructions for use

Signs and symbols

The following symbols appear in the instructions for use and on the type plate:

WARNING Warning instruction indicating a risk of injury or damage to health.

IMPORTANT

Safety note indicating possible damage to the unit / accessory or material damage,

e.g. through escaping water.

NOTE Note on important information.

The unit is double-protected and thus corresponds to protection class 2.

1. Safety notes

Electric shock

WARNING

A

s with every electrical device, use this air humidifier carefully and cautiously, in order to avoid

hazards due to electric shock.

T

herefore, observe the following instructions for use:

use device with the power supply unit provided and the mains voltage specified on the power

supply unit only,

never use the air humidifier if the device or its accessories show visible signs of damage,

do not use the device if it has sustained a fall or if water has penetrated the device interior.

8

In the case of defects or operational faults, switch the device off immediately and disconnect

the device from the mains socket. Do not pull on the mains cable or on the device to disconnect

the power supply unit from the socket. Never plug in or unplug the power supply unit when you

have wet hands. Never hold or carry the device by the mains cable. Keep the cables away from

hot surfaces. Never reach for a device that has been submerged in water. Pull the plug out of the

mains socket immediately.

Repairs

WARNING

The base of the air humidifier must not be opened.

Only specialist personnel may perform repairs on electrical devices. Improper repairs may subject

users to considerable danger. For repairs, please contact customer service or an authorised

retailer.

If the mains cable of the device is damaged, it must be replaced by the manufacturer or an

authorised customer service point.

Notes

WARNING

If you suffer from a severe respiratory or lung disease, consult your doctor before using the air

humidifier.

Ensure that the mains cable does not pose a trip hazard.

IMPORTANT

Ensure that the device is placed on a firm, flat surface that is not susceptible to moisture, is not

raised and that it cannot be knocked over.

To avoid damage from the escaping mist, the device must not be placed on the floor.

Do not expose the air humidifier to direct sunlight.

Do not insert any objects into openings on the device.

Disposal

Observe the local regulations for material disposal. Dispose of the unit in accordance with EC

Directive 2002/96/EC WEEE (Waste Electrical and Electronic Equipment). If you have any

questions, please contact the local authorities responsible for waste disposal.

2. Intended use

This air humidifier is intended to humidify the air indoors.

WARNING

This device is not intended for use by people (including children) with restricted physical, sensory

or mental skills or a lack of experience and/or a lack of knowledge, unless they are supervised

or instructed, for their own safety, by a person who is familiar with the device.

Children should be supervised around the device to ensure they do not play with it.

The device is only intended for the purpose described in these instructions for use. The manu-

facturer is not liable for damage resulting from improper or careless use.

9

3. Getting to know your instrument

Humans spend a large proportion of their time indoors. For ideal ambient air, a humidity level of between

40% and 60% is recommended. This value is often not reached, particularly in winter, when cold, dry air

enters living spaces that are being aired and is then warmed up. This dry ambient air draws in moisture,

drying out mucous membranes and skin, but also furniture.

Ambient air that is too dry has a number of negative effects:

Mucous membranes and lips dry out

Eyes become irritated

Infections and respiratory diseases are more likely to occur

Exhaustion, tiredness and difficulty concentrating

Pets and plants are put under unnecessary strain

Dust forms more quickly

Electrostatic charging of textiles made of synthetic fibres, such as carpets and plastic floor

coverings

Wooden furniture and, especially, parquet floors, are damaged

Musical instruments go out of tune

With this air humidifier, you can bring additional humidity into the ambient air – everywhere: at home, on

the move or in the office. You only require a standard plastic water bottle that you use as a water tank

with the adapter provided. For this reason, and due to its compact size, this air humidifier can be taken

with you when you travel and mounted on a small surface. With the storage pouch, all of the accessories

are always close at hand.

4. Unit description

1

1. Mist outlet

5

2. Top

2

3. Bottle adapter

6

4. Power supply unit

3

5. Air outlet

7

6. Draining outlet

7. LED

4

8. Ultrasonic membrane

9. Base

8

10. Control dial

11. Connector socket for power supply unit

12. Cleaning brush

5. Operation

10 11 129

IMPORTANT

Never touch the ultrasonic membrane during operation.

10

Do not add any essential oils or fragrances to the water. This would damage the ultrasonic

source.

Operate the air humidifier only when it has been completely assembled and is fully

functioning.

Use a plastic bottle no larger than 0.5 litres or fill a bottle with a maximum of 0.5 litres. Otherwise,

the raised water pressure may cause the air humidifier to overflow.

Operate the air humidifier only with top and mist outlet mounted so as to avoid splashing in the

vicinity.

Never use liquids other than water.

Please observe the safety notes and the additional notes so as to avoid damage.

Initial use

Remove the packaging material.

Check the device, mains plug and cable for damage.

Place the air humidifier on a even, firm, flat and humidity-resistant surface. Ensure that the air humidi-

fier cannot be knocked over.

Position the air humidifier in a raised place, e.g. a table, chest of drawers, chair or bedside table. To

avoid damage from the escaping mist, the device must not be placed on the floor.

Ensure than the top is placed firmly on the base. Pull the mist outlet upwards until it noticeably engages.

For this purpose, you must overcome the rest resistance in the initial position with a forceful tug.

Make sure that the escaping mist is not directed at the bottle, wall, plug socket or other objects and

that the air outlet always remains free.

Fill a 0.5 litre plastic water bottle with clean tap water, distilled water or still water. Do not use carbon-

ated water. The manufacturer expressly recommends the use of distilled water so as to avoid limescale.

The water temperature may be a maximum of 50 °C, so as to avoid damage to the device.

Fasten a bottle adapter onto the bottle. There are two adapters available that fit most standard plastic

bottles:

1. “PC 1810” thread with a thread diameter of 28 mm and

2. “30/25” thread with a thread diameter of 30 mm.

Turn the bottle upside down and place it in the top of the air humidifier. Do not compress the plastic

bottle. The base will fill with water automatically.

Connect the power supply unit connector plug with the connector socket of the air humidifier and

insert the power supply unit into the socket. Ensure that the cable does not pose a trip hazard.

Turn the control dial clockwise (to the right) to switch on the air humidifier.

Use the device and switch off.

IMPORTANT

The immediate vicinity of the air humidifier may become damp. Reduce the nebulisation per-

formance or put the device in a more suitable place.

Calcareous water can leave white deposits. Use distilled water instead.

If the device should accidentally tip over, water may escape, even if the device is switched off

and unplugged.

Check the humidity of your ambient air regularly. Intensive continuous operation can cause the

ambient air to become excessively humid. The relative air humidity should not exceed 60%.

11

By turning the control dial to the right, you can adjust the nebulisation performance between “MIN”

and “MAX”.

Through operation, the device and the water in the base warm up.

To switch the air humidifier on again, turn the control dial to the left.

Device automatically switches off if the water runs out.

Switch off the device when refilling the bottle with water. Change the water in the bottle every day so

that fresh water is always taken in.

Switch off the device and pull out the plug when you are not using the air humidifier.

Empty any remaining water when the device is not in use.

6. Cleaning, maintenance and storage

Weekly cleaning and disinfection is a requirement for fault-free and hygienic operation.

WARNING

S

witch off the air humidifier each time before cleaning. Pull the plug out of the mains socket.

IMPORTANT

Never submerge the base in water.

Important! Empty the water from the base unit via the side rim. Ensure that no water gets inside

the device, e.g. via the air outlet or the control dial.

Completely clean the bottle and the air humidifier if the device has not been used for over three

days.

Clean the device using only the methods specified.

Do not use any solvent-based cleaning products.

Use only a mild detergent or vinegar/vinegar-based cleaner to perform cleaning or disinfection

work.

Clean all parts that come into contact with water on a weekly basis. Let the device cool down for ap-

prox. 60 minutes.

Completely remove the mist outlet, then remove the top in an upward direction.

Make sure that the ultrasonic membrane always remains free from limescale so as to ensure a long

service life. Always use the cleaning brush for this purpose and apply standard descaling agents. Leave

the descaling agent to work for as long as is required to dissolve all the limescale and dirt deposits. To

avoid damaging the ultrasonic membrane, never scrape with sharp, hard objects. Rinse out the base

if necessary.

Wipe the interior of the base with a cloth. Use a mild cleaning product. Rinse out the base if

necessary.

Wipe the exterior housing of the base with a damp cloth.

Clean all removable parts, such as the bottle, bottle adapter, mist outlet and top, with a mild detergent

or vinegar/vinegar-based cleaner. Clean the parts thoroughly, particularly the bottle.

Bottle adapter, mist outlet and top are dishwasher-safe.

Dry the parts with a soft cloth and only reassemble them when they are completely dry.

For storage and easy transport, e.g. for travel, a storage pouch is available.

12