Beurer MC 2000: 7. Maintenance and storage 8. What if there are problems?

18

Warning!

•  The device must be switched off using the hand 

switch after every use and before cleaning.

•  Pull the mains plug out of the socket. 

•  Retract the mains cable.

>

Wipe the Shiatsu office chair from time to time with 

a dry, lint-free or slightly damp cloth.

>

Every two to three months, wipe the office chair 

using a clean cloth with a small amount of care 

product for artificial leather.

>

Afterwards, dry the office chair with a clean, dry 

cloth.

Artificial leather is sensitive to grease. Clean the 

Shiatsu office chair only using care products suitable 

for artificial leather.

Important!

•  Clean the device using only the methods specified.

•  Under no circumstances may liquid enter the 

device.

•  Do not use any solvent-based cleaning products.

•  Do not use any harsh cleaning products.  

These can damage the surface.

7.  Maintenance and storage 8.  What if there are problems?

Problem

Cause

Solution

Massage heads are 

moving slowly.

The load on the massage heads is too 

great.

>

Reduce the contact pressure from 

your body.

Massage heads are 

moving in the upper or 

lower area only.

The massage was only activated for the 

limited area in question.

>

Press the FULL BACK, UPPER 

BACK or LOWER BACK button to 

change or extend the area.

Grinding noises during 

operation.

These sounds are normal and are caused 

by the operation of the motor or from the 

massage heads that are rubbing against 

the cushion.

No action is necessary.

The massage cannot be 

started.

The mains plug is not connected to the 

socket.

>

Plug the mains plug into the socket.

The Shiatsu massage was not switched on 

at the hand switch.

>

Start the Shiatsu massage using 

the on/off button 

.

The massage function 

stops when the chair is in 

operation.

The maximum operation period was 

reached.

>

Switch off the Shiatsu office chair 

and allow to cool down for 30 

minutes before switching on again.