Sony CPD-E400P: Self-diagnosis function Specifications

Self-diagnosis function

Specifications

This monitor is equipped with a self-diagnosis function. If there is

a problem with your monitor or computer, the screen will go

CRT 0.24 mm aperture grille pitch (center)

blank and the 1 (power) indicator will either light up green or

19 inches measured diagonally

flash orange. If the 1 (power) indicator is lit in orange, the

90-degree deflection

computer is in power saving mode. Try pressing any key on the

FD Trinitron

keyboard or moving the mouse.

Viewable image size Approx. 365 × 274 mm (w/h)

3

7

(14

/

8

× 10

/

8

inches)

18.0" viewing image

Resolution

RESET

MENU

Maximum Horizontal: 1800 dots

Vertical: 1440 lines

Recommended Horizontal: 1280 dots

1

(power) indicator

Vertical: 1024 lines

Standard image area Approx. 352 × 264 mm (w/h)

7

1

(13

/

8

× 10

/

2

inches)

If the

1

(power) indicator is green

Deflection frequency* Horizontal: 30 to 96 kHz

Vertical: 48 to 120 Hz

1

Disconnect the video input cable or turn off the

AC input voltage/current 220 to 240 V, 50 – 60 Hz, 1.0 A

connected computer.

Power consumption 140 W

Operating temperature 10°C to 40°C

2

Press the

1

(power) button twice to turn the monitor

Dimensions

Approx. 446

×

464

×

461 mm

off and then on.

5

3

1

(w/h/d)

(17

/

8

× 18

/

8

× 18

/

4

inches)

3

Move the control button

,

for 2 seconds before the

Mass Approx. 26 kg (57 lb 5 oz)

monitor enters power saving mode.

Plug and Play DDC1/DDC2B/DDC2Bi/GTF

MENU

Supplied accessories See page 6

* Recommended horizontal and vertical timing condition

• Horizontal sync width should be more than 1.0 µsec.

• Horizontal blanking width should be more than 3.0 µsec.

• Vertical blanking width should be more than 500 µsec.

If all four color bars appear (white, red, green, blue), the monitor

Design and specifications are subject to change without notice.

is working properly. Reconnect the video input cable and check

the condition of your computer.

If the color bars do not appear, there is a potential monitor failure.

Inform your authorized Sony dealer of the monitor’s condition.

If the

1

(power) indicator is flashing orange

Press the

1

(power) button twice to turn the monitor off

and then on.

If the 1 (power) indicator lights up green, the monitor is working

properly.

If the 1 (power) indicator is still flashing, there is a potential

monitor failure. Count the number of seconds between orange

flashes of the 1 (power) indicator and inform your authorized

Sony dealer of the monitor’s condition. Be sure to note the model

name and serial number of your monitor. Also note the make and

model of your computer and graphic board.

18