Sony Bravia KDL-26U25xx: Specifications
Specifications: Sony Bravia KDL-26U25xx
Table of contents
- Trademark information Introduction Disposal of the TV set Notice for Digital TV function
- Table of Contents
- 1: Checking the 2: Connecting an aerial/ accessories VCR
- 3: Bundling the cables 4: Preventing the TV from toppling over 5: Selecting the language and country/region
- 6: Auto-tuning the TV
- Safety information Installation/Set-up Mains lead
- Precautions Prohibited Usage Broken pieces: When not in use For children If the following problems occur...
- Overview of the remote
- Overview of the TV buttons and indicators Watching TV
- Additional operations To access Text Picture Freeze PIP in PC Mode (Picture in Picture)
- Checking the Digital Electronic Programme Guide (EPG) To Do this
- Using the Favourite list To Do this
- Navigating through menus
- Picture Adjustment menu
- Sound Adjustment menu
- Features menu
- Timer Set-up menu
- Sound Offset Manual Programme Preset
- Digital Set-up menu
- Connecting optional equipment Connecting to the TV (side)
- Connecting to the TV (rear)
- Viewing pictures from connected equipment
- Specifications
- Troubleshooting Picture Problem Cause/Remedy
- Sound Channels General

010COV.book Page 24 Tuesday, June 26, 2007 12:18 PM
Additional Information
HYPER: S21–S41
Specifications
D/K: R1–R12, R21–R69
L: F2–F10, B–Q, F21–F69
Display Unit
I: UHF B21–B69
Power Requirements:
Digital: VHF/UHF
220–240 V AC, 50 Hz
Terminals
Screen Size:
KDL-40U25xx: 40 inches
/1
KDL-32U25xx: 32 inches
21-pin Scart connector (CENELEC standard) including
KDL-26U25xx: 26 inches
audio/video input, RGB input, and TV audio/video
Display Resolution:
output.
1,366 dots (horizontal) × 768 lines (vertical)
/ 2 (SMARTLINK)
Power Consumption:
21-pin Scart connector (CENELEC standard) including
KDL-40U25xx: 190 W or less
audio/video input, RGB input, selectable audio/video
KDL-32U25xx: 115 W or less
output, and SMARTLINK interface.
KDL-26U25xx: 100 W or less
3
Standby Power Consumption*:
Supported formats: 1080i, 720p, 576p, 576i, 480p, 480i
KDL-40U25xx: 0.8 W or less
Y: 1 Vp-p, 75 ohms, 0.3V negative sync
KDL-32U25xx: 1 W or less
P
B/CB: 0.7 Vp-p, 75 ohms
KDL-26U25xx: 1 W or less
P
R/CR: 0.7 Vp-p, 75 ohms
* Specified standby power is reached after the TV
3
finishes necessary internal processes.
Audio input (phono jacks)
Dimensions (w × h × d):
500 mVrms
KDL-40U25xx:
Impedance: 47 kilo ohms
Approx. 988 × 687 × 270 mm (with stand)
4 S video input (4-pin mini DIN)
Approx. 988 × 653 × 128 mm (without stand)
KDL-32U25xx:
4 Video input (phono jack)
Approx. 797 × 580 × 220 mm (with stand)
4 Audio input (phono jacks)
Approx. 797 × 548 × 125 mm (without stand)
Audio output (Left/Right) (phono jacks)
KDL-26U25xx:
PC PC Input (15 Dsub) (see page 22)
Approx. 663 × 503 × 220 mm (with stand)
G: 0.7 Vp-p, 75 ohms, non Sync on Green
Approx. 663 × 472 × 128 mm (without stand)
B: 0.7 Vp-p, 75 ohms, non Sync on Green
Mass:
R: 0.7 Vp-p, 75 ohms, non Sync on Green
KDL-40U25xx:
HD: 1-5 Vp-p
Approx. 24,0 kg (with stand)
VD: 1-5 Vp-p
Approx. 21,0 kg (without stand)
PC audio input (minijack)
KDL-32U25xx:
Approx. 15,0 kg (with stand)
HDMI IN 6, 7
Approx. 13,0 kg (without stand)
Video: 1080i, 720p, 576p, 576i, 480p, 480i
KDL-26U25xx:
Audio: Two channel linear PCM
Approx. 12,0 kg (with stand)
32, 44.1 and 48 kHz, 16, 20 and 24 bits
Approx. 10,0 kg (without stand)
Analogue audio (phono jacks):
Panel System
500 mVrms, Impedance 47 kilohms
LCD (Liquid Crystal Display) Panel
(HDMI IN 7 only)
i Headphones jack
TV System
CAM (Conditional Access Module) slot
Analogue: Depending on your country/region selection:
Sound Output
B/G/H, D/K, L, I
Digital: DVB-T
KDL-40U25xx: 10 W + 10 W (RMS)
KDL-32U25xx: 10 W + 10 W (RMS)
Colour/Video System
KDL-26U25xx: 10 W + 10 W (RMS)
Analogue: PAL, SECAM
Supplied Accessories
NTSC 3.58, 4.43 (only Video In)
Digital: MPEG-2 MP@ML
Refer to “1: Checking the accessories” on page 4.
Aerial
Optional Accessories
75 ohm external terminal for VHF/UHF
• Wall-Mount Bracket
SU-WL51 (for KDL-40U25xx)
Channel Coverage
SU-WL31 (for KDL-32U25xx / KDL-26U25xx)
Analogue: VHF: E2–E12
Design and specifications are subject to change
UHF: E21–E69
without notice.
CATV: S1–S20
GB
24

