Sony CPD-E430: Owner’s Record

Owner’s Record

NOTICE

The model and serial numbers are located at the rear of the unit.

This notice is applicable for USA/Canada only.

Record these numbers in the spaces provided below. Refer to them

If shipped to USA/Canada, install only a UL LISTED/CSA

whenever you call upon your dealer regarding this product.

LABELLED power supply cord meeting the following

Model No.

Serial No.

specifications:

SPECIFICATIONS

Plug Type Nema-Plug 5-15p

WARNING

Cord Type SVT or SJT, minimum 3

× 18 AWG

Length Maximum 15 feet

To prevent fire or shock hazard, do not expose the

Rating Minimum 7 A, 125 V

unit to rain or moisture.

NOTICE

Dangerously high voltages are present inside the

Cette notice s’applique aux Etats-Unis et au Canada

unit. Do not open the cabinet. Refer servicing to

uniquement.

qualified personnel only.

Si cet appareil est export* aux Etats-Unis ou au Canada,

utiliser le cordon d’alimentation portant la mention UL LISTED/

FCC Notice

CSA LABELLED et remplissant les conditions suivantes:

This equipment has been tested and found to comply with the limits

SPECIFICATIONS

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

Type de fiche Fiche Nema 5-15 broches

These limits are designed to provide reasonable protection against

Cordon Type SVT ou SJT, minimum 3

× 18 AWG

harmful interference in a residential installation. This equipment

Longueur Maximum 15 pieds

generates, uses, and can radiate radio frequency energy and, if not

Tension Minimum 7 A, 125 V

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

As an

ENERGY STAR Partner, Sony

– Connect the equipment into an outlet on a circuit different from

Corporataion has determined that this

that to which the receiver is connected.

product meets the

ENERGY STAR

– Consult the dealer or an experienced radio/TV technician for

guidelines for energy efficiency.

help.

You are cautioned that any changes or modifications not expressly

approved in this manual could void your authority to operate this

equipment.

EN 55022 Compliance (Czech Republic Only)

This device belongs to category B devices as described in EN

This monitor complies with the TCO’99

55022, unless it is specifically stated that it is a category A

guidelines.

device on the specification label. The following applies to

devices in category A of EN 55022 (radius of protection up to

30 meters). The user of the device is obliged to take all steps

necessary to remove sources of interference to

telecommunication or other devices.

If you have any questions about this product, you may call:

Sony Customer Information Center

1-800-222-SONY (7669)

or write to:

Sony Customer Information Center

1 Sony Drive, Mail Drop #T1-11, Park Ridge, NJ 07656

INFORMATION

Declaration of Conformity

This product complies with Swedish National Council for Metrology

(MPR) standards issued in December 1990 (MPR II) for very low

Trade Name: SONY

frequency (VLF) and extremely low frequency (ELF).

Model No.: CPD-E430

INFORMATION

Responsible Party: Sony Electronics Inc.

Ce produit est conforme aux normes du Swedish National Council

Address: 680 Kinderkamack Road, Oradell,

for Metrology de décembre 1990 (MPR II) en ce qui concerne les

NJ 07649 USA

fréquences très basses (VLF) et extremement basses (ELF).

Telephone No.: 201-930-6972

INFORMACIÓN

Este producto cumple las normas del Consejo Nacional Sueco

This device complies with Part 15 of the FCC Rules. Operation

para Metrología (MPR) emitidas en diciembre de 1990 (MPR II)

is subject to the following two conditions: (1) This device may

para frecuencias muy bajas (VLF) y frecuencias extremadamente

not cause harmful interference, and (2) this device must accept

bajas (ELF).

any interference received, including interference that may

cause undesired operation.

2