Sony BRAVIA KDL-20S2020: Additional Information Specifications
Additional Information Specifications: Sony BRAVIA KDL-20S2020
Table of contents
- Trademark information Introduction Notice for Digital TV function
- Table of Contents
- Start-up Guide 1: Checking the 2: Connecting an aerial/ accessories VCR
- 3: Bundling the cables 4: Preventing the TV from toppling over 5: Selecting the language and country/region
- 6: Auto-tuning the TV
- Safety information
- GB
- GB
- Precautions
- Overview of the remote
- Overview of the TV buttons and indicators
- Watching TV
- To access Text Picture Freeze PIP in PC Mode (Picture in Picture) To change the screen mode manually to suit the broadcast GB
- Checking the Digital Electronic Programme Guide To Do this
- To Do this
- Using the Favourite list To Do this
- Viewing pictures from connected equipment
- Navigating through menus
- Picture Adjustment menu
- Sound Adjustment menu
- TV Speakers
- Features menu
- Timer
- Set-up menu
- Manual Programme Preset
- Skip
- Digital Set-up menu Digital Tuning
- Digital Set-up
- Using Optional Equipment Connecting optional equipment Connecting to the TV (side)
- Connecting to the TV (rear)
- Additional Information Specifications
- Troubleshooting Picture
- Sound Channels General
010COV.book Page 32 Monday, June 12, 2006 3:29 PM
Additional Information
Terminals
Specifications
/1
21-pin Scart connector (CENELEC standard) including
Display Unit
audio/video input, RGB input, and TV audio/video
Power Requirements:
output.
220–240 V AC, 50 Hz
/ 2 (SmartLink)
Screen Size:
21-pin Scart connector (CENELEC standard) including
20 inches
audio/video input, RGB input, selectable audio/video
Display Resolution:
output, and SmartLink interface.
1,366 dots (horizontal) × 768 lines (vertical)
3
Power Consumption:
Supported formats: 1080i, 720p, 576p, 576i, 480p, 480i
65 W or less
Y: 1 Vp-p, 75 ohms, 0.3V negative sync
Standby Power Consumption:
P
B/CB: 0.7 Vp-p, 75 ohms
1 W or less
P
R/CR: 0.7 Vp-p, 75 ohms
Dimensions (w × h × d):
3
Approx. 500 × 406 × 209 mm (with stand)
Audio input (phono jacks)
Approx. 500 × 370 × 100 mm (without stand)
500 mVrms
Mass:
Impedance: 47 kilo ohms
Approx. 8 kg (with stand)
4 S video input (4-pin mini DIN)
Approx. 7 kg (without stand)
4 Video input (phono jack)
Panel System
4 Audio input (phono jacks)
LCD (Liquid Crystal Display) Panel
PC 5 PC Input (15 Dsub) (see page 31)
TV System
G: 0.7 Vp-p, 75 ohms, non Sync on Green
B: 0.7 Vp-p, 75 ohms, non Sync on Green
Analogue: Depending on your country/region selection:
R: 0.7 Vp-p, 75 ohms, non Sync on Green
B/G/H, D/K, L, I
HD: 1-5 Vp-p
Digital: DVB-T
VD: 1-5 Vp-p
Colour/Video System
5 PC audio input (minijack)
Analogue: PAL, SECAM
HDMI IN 6
NTSC 3.58, 4.43 (only Video In)
Video: 1080i, 720p, 576p, 576i, 480p, 480i
Digital: MPEG-2 MP@ML
Audio: Two channel linear PCM
Aerial
32, 44.1 and 48 kHz, 16, 20 and 24 bits,
75 ohm external terminal for VHF/UHF
or analogue audio input (phono jacks)
i Headphones jack
Channel Coverage
CAM (Conditional Access Module) slot
Analogue: VHF: E2–E12
UHF: E21–E69
Sound Output
CATV: S1–S20
5 W + 5 W (RMS)
HYPER: S21–S41
Supplied Accessories
D/K: R1–R12, R21–R69
Refer to “1: Checking the accessories” on page 4.
L: F2–F10, B–Q, F21–F69
I: UHF B21–B69
Design and specifications are subject to change
Digital: VHF/UHF
without notice.
PC Input Signal Reference Chart
Horizontal
Vertical
Signals Horizontal (Pixel) Vertical (Line)
Standard
frequency (kHz)
frequency (Hz)
VGA 640 480 31.5 60 VGA
SVGA 800 600 37.9 60 VESA Guidelines
XGA 1024 768 48.4 60 VESA Guidelines
WXGA 1280 768 47.4 60 VESA
1280 768 47.8 60 VESA
• This TV’s PC input does not support Sync on Green or Composite Sync.
• This TV’s PC input does not support interlaced signals.
• This TV’s PC input supports signals in the above chart with a 60 Hz vertical frequency. For other signals, you will see the
message “NO SYNC”.
32
GB
2-685-333-41(0)
KDL-20S2020
