Sony CDX-M600R: Troubleshooting guide General CD/MD playback
Troubleshooting guide General CD/MD playback: Sony CDX-M600R
Table of contents
- Welcome ! Precautions
- Notes on CDs
- Table of Contents
- Location of controls
- Location of controls
- The corresponding buttons of the unit control the same functions as those on the card remote commander.
- Turning the unit on/off Getting Started Resetting the unit Security release settings
- How to use the menu Setting the clock
- CD Player CD/MD Unit (optional) Listening to a CD
- Locating a specific track Locating a specific point in a track Automatically scrolling a disc name Locating a disc
- Playing tracks repeatedly Playing tracks in random — Repeat Play order — Shuffle Play
- Labelling a CD — Disc Memo
- Locating a disc by name
- Selecting specific tracks for playback
- Memorising only the Radio desired stations Memorising stations automatically
- Receiving the memorised stations
- RDS Overview of the RDS Retuning the same function programme automatically Displaying the station name
- Listening to a regional programme Local link function
- Listening to traffic announcements
- Presetting the RDS stations with the AF and TA data
- Locating a station by programme type
- Setting the clock DAB automatically Overview of DAB
- Basic operations of DAB
- Presetting DAB services Presetting DAB services automatically — BTM manually
- Listening to a DAB programme
- Settings on the audio Locating a DAB service by reception programme type (PTY)
- DSP (CDX-M700R only) Setting the equalizer
- Selecting the listening Selecting a soundstage position menu
- Adjusting the balance Adjusting the front and rear fader
- Adjusting the volume of the subwoofer(s) Listening to each programme source in its registered DSO
- Using the rotary Other Functions commander Labelling the rotary commander
- By rotating the control Other operations (the SEEK/AMS control) By pushing in and rotating the control (the PRESET/DISC control)
- Changing the operative direction Adjusting the sound characteristics (CDX-M600R only) Attenuating the sound
- Changing the sound and display settings
- Boosting the bass sound Selecting the spectrum analyser
- Additional Adjusting the sound and Information frequency of the equalizer preamplifier Maintenance
- Dismounting the unit
- If the front panel does not open because of a blown fuse
- Specifications
- Troubleshooting guide General CD/MD playback
- Radio reception RDS
- Error displays (when an optional CD/MD unit is connected)
Troubleshooting guide
The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
General
Problem
Cause/Solution
No sound.
•Cancel the ATT function.
•Set the fader control to the centre position for two-speaker
system.
•Press (+) of the VOL button to adjust the volume.
The contents of the memory
•The power cord or battery has been disconnected.
have been erased.
•The reset button has been pressed.
t Store again into the memory.
No beep sound.
The beep sound is cancelled (page 35).
The sound is noisy.
You are using a mobile phone.
CD/MD playback
Problem
Cause/Solution
A disc cannot be loaded.
•Another CD is already loaded.
•The CD is forcibly inserted upside down or in the wrong
way.
Playback does not begin.
Defective MD or dirty CD.
A disc is automatically ejected.
The ambient temperature exceeds 50°C.
CD will not be ejected.
You have closed the front panel or pushed the disc forcibly
into the unit while the unit was ejecting the disc after you
pressed Z.
t Press the reset button.
The operation buttons do not
Press the reset button.
function.
The sound skips due to
•The unit is installed at an angle of more than 60°.
vibration.
•The unit is not installed in a sturdy part of the car.
The sound skips.
A dirty or defective disc.
Cannot turn off the “--------”
You cannot label CDs unless you connect a CD unit with the
indication.
custom file function.
t Press (LIST) for two seconds.
41
