Remington BHT2000: ENGLISH

ENGLISH

GBDNLFEIDKSFINPSKCZ

GB

Thank you for choosing Remington. Our products are designed to meet the high-

est standard of quality, functionality and design. We hope you enjoy using your

new Remington

®

product. Please read the instructions for use carefully and keep

in a safe place for future reference.

CAUTION

Use this appliance only for its intended use as described in this manual.

Do not use attachments not recommended by Remington.

Do not use this product if it is not working correctly, if it has been

dropped or damaged, or dropped into water.

DESCRIPTION

1. 5 Position “Zoom wheel”

2. Length position indicator

3. Adjustable trimmer comb attachment

4. Dual foil shaving attachment

HUN

5. Cutting assembly

PL

6. ON/OFF switch

RUTRROGRSLAE

7. Charging indicator

8. Charging adapter

HR/

SRB

1

080706_REM_IFU_BHT2000_22L.indd GB1080706_REM_IFU_BHT2000_22L.indd GB1 05.11.2008 12:21:48 Uhr05.11.2008 12:21:48 Uhr

ENGLISH

GETTING STARTED

Be patient when first using your body trimmer. As with any new product, it may take a little

while to familiarise yourself with the product. Take the time to acquaint yourself with your

new trimmer, as we are confident you will receive years of enjoyable use and complete

satisfaction.

CHARGING YOUR BODY TRIMMER

Before using your body trimmer for the first time, charge for 14-16 hours.

Ensure the product is switched off.

Connect the charging adaptor to the product and then to the mains.

The charging indicator will light up.

Use product until the battery is low.

Your trimmer cannot be overcharged. However, if the product is not going to be used for an

extended period time (2-3 months), unplug it from the mains and store. Fully recharge your

body trimmer when you would like to use it again.

To preserve the life of your batteries, let them run out every six months then recharge for

14-16 hours.

HOW TO USE

ADJUSTING THE TRIM LENGTH (Diagram A)

The trimmer comb can be adjusted to give you 5 different trim lengths simply by turning the

Zoom wheel to the desired setting. Turn the Zoom wheel clockwise for shorter length, anti-

clockwise for longer length. The wheel will click into place as it reaches each setting, and the

setting number will appear on the length position indicator.

Setting Length

13 mm

25 mm

37 mm

48 mm

512 mm

2

080706_REM_IFU_BHT2000_22L.indd GB2080706_REM_IFU_BHT2000_22L.indd GB2 05.11.2008 12:21:48 Uhr05.11.2008 12:21:48 Uhr

ENGLISH

GB

GBDNLFEIDKSFINPSKCZ

NOTE: Trimmer comb must be attached to the product in order to use the hair length

selector.

TRIMMING (Diagram B)

Use the zoom wheel to set the trimmer comb to the desired length setting. The

setting will appear on the length position indicator. If you are trimming for the first time

start with the maximum trimming length setting (5).

Turn the unit on.

Place the flat top of the trimmer comb against the skin.

Slowly slide the trimmer through the hair, in the direction of hair growth.

If hair builds up in the trimmer comb during the trimming process, switch the unit

off, pull off the adjustable trimmer comb. Brush trimmer/rinse comb.

For a closer and precise shaping, remove the adjustable trimmer comb and trim the

hairs along the outer edge.

When you finish, turn the product off, clean, and return it to its storage pouch.

EDGING AND SHAPING (Diagram C)

Remove the Trimmer Comb Attachment.

Hold the Trimmer at a right angle to your skin and press down gently.

Edge and shape the area as desired.

USING THE SHAVER ATTACHMENT (Diagram D)

Hold the shaving head to your skin.

Stretch your skin with your free hand so hairs stand upright.

Only apply light pressure on the shaving head while shaving.

Shave against hair growth.

The Microscreen shaving technology with circular foil holes is developed to give a

HUN

controlled close cut.

PL

EXCHANGING THE ATTACHMENTS

Always ensure the trimmer is switched off before changing the trimmer and shaver

RUTRROGRSLAE

attachments.

REMOVING THE TRIMMER COMB AND CUTTING ASSEMBLY

Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel to keep

it from turning.

With your other hand, gently pull the trimmer comb attachment off the Trimmer.

Remove the cutting assembly by firmly pushing up on the blade with your thumb

(Diagram E & F).

REMOVING THE SHAVER ATTACHMENT

Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel to keep

it from turning.

HR/

SRB

With your other hand, gently pull the Shaver Attachment off the Trimmer.

3

080706_REM_IFU_BHT2000_22L.indd GB3080706_REM_IFU_BHT2000_22L.indd GB3 05.11.2008 12:21:48 Uhr05.11.2008 12:21:48 Uhr

ENGLISH

REMOVING THE SHAVER COVER (Diagram G)

Gently push the buttons either side of the shaving foil. With the other hand lift the

shaver cover. Clean then replace.

REPLACING THE CUTTER ASSEMBLY

Hold the Trimmer in one hand. With your other hand, insert the lower part of the

cutter assembly into the Trimmer, push down the cutter until firmly attached.

REPLACING THE TRIMMER COMB AND SHAVER ATTACHMENT

(Diagram H)

Hold the Trimmer in one hand with your thumb firmly on the Zoom wheel to keep

it from turning. Ensure that the Length Position Indicator is at 1.

Slide the comb/shaver down the grooves until it clicks into place.

NOTE: The trimmer comb and shaver attachment can only be attached in one way.

If it does not go on correctly, turn it around and try again.

REPLACING THE FOILS & CUTTERS

To ensure the continued highest quality performance from your shaver, we recommend that

the foil and cutter are replaced regularly.

Signs that your foils and cutters need replacing:

1. Irritation: As foils get worn, you may experience skin irritation.

2. Pulling: As the cutters wear, your shave may not feel as close and you may feel your

cutter pulling your hair.

3. Wear through: You may notice that the cutters have worn through the foils.

Replacement cutters and foils available. Model: SP02.

CARE FOR YOUR TRIMMER

Care for your product to ensure a long lasting performance. We recommend you clean your

shaver after each use. The easiest and the most hygienic way to clean the shaver is by rinsing

the product head after use with warm water. Always keep the trimmer in the “off” position

when not in use.

AFTER EACH USE

Turn Trimmer off.

Remove the adjustable trimmer comb and cutter assembly or shaver attachment.

Gentle tap on a flat surface to remove hair particles, and brush the remaining hairs

away/rinse under warm water (Diagram I).

CLEANING CAUTIONS

Only the adjustable trimmer comb and cutter assembly may be removed from the

Trimmer for cleaning.

4

080706_REM_IFU_BHT2000_22L.indd GB4080706_REM_IFU_BHT2000_22L.indd GB4 05.11.2008 12:21:48 Uhr05.11.2008 12:21:48 Uhr

ENGLISH

GB

GBDNLFEIDKSFINPSKCZ

Cleaning should only be done with a soft brush, such as the brush supplied with the

product.

Only use the light-grade oil supplied or sewing machine oil on the blades.

Do not use harsh or corrosive cleaners on the units or their cutters.

Do not apply pressure or hard objects to cutters.

Do not disassemble cutter assembly.

Do not submerge in water as damage will occur.

STORAGE

Always store this appliance and cord in a moisture-free area. Do not store it in

temperatures exceeding 140°F (60°C).

Do not wrap the cord of the charging adaptor around the appliance.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR

INJURY TO PERSONS:

An appliance should never be left unattended when plugged in to a power outlet.

Keep the power plug and cord away from heated surfaces.

Make sure the power plug and cord do not get wet.

Do not unplug the product with wet hands.

Do not use the product with a damaged cord. A replacement can be obtained via

our International Service Centres listed at the back of this booklet.

Use and store the product at a temperature between 15°C and 35°C.

HUN

Always unplug from the mains when cleaning or when being used under running

water.

PL

Only use the parts supplied with the appliance.

This product is for cordless use only. Do not use your Trimmer while it is plugged

into the mains.

RUTRROGRSLAE

Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge can

give cause to hazards. Persons responsible for their safety should give explicit instructions

or supervise the use of the appliance.

PROTECT THE ENVIRONMENT

The product contains a Nickel Metal Hydride cell unit. Do not dispose the trimmer in

household waste at the end of its useful life. Disposal can take place at our service centres

or appropriate collection sites.

HR/

SRB

CAUTION: Do not put in fire or mutilate your battery packs as they may burst or release

toxic materials.

5

080706_REM_IFU_BHT2000_22L.indd GB5080706_REM_IFU_BHT2000_22L.indd GB5 05.11.2008 12:21:48 Uhr05.11.2008 12:21:48 Uhr

ENGLISH

For further information on recycling see www.remington-europe.com

SERVICE & WARRANTY

This product has been checked and is free of defects. We warrant this product against any

defects that are due to faulty material or workmanship for a year period from the original

3

date of consumer purchase. If the product should become defective within the warranty

period, we will repair any such defect or elect to replace the product or any part of it

without

charge provided there is proof of purchase. This does not mean an extension of the warranty

period.

In the case of a warranty simply call the Remington

®

Service Centre in your region.

This warranty is offered over and above your normal statutory rights.

The warranty shall apply in all countries in which our product was sold via an authorised

dealer.

This warranty does not include shaving heads/foils and cutters which are consumable parts.

Also not covered is damage to the product by accident or misuse, abuse, alteration to the

product or use inconsistent with the technical and/or safety instructions required. This

warranty shall not apply if the product has been dismantled or repaired by a person not

authorised by us.

6

080706_REM_IFU_BHT2000_22L.indd GB6080706_REM_IFU_BHT2000_22L.indd GB6 05.11.2008 12:21:49 Uhr05.11.2008 12:21:49 Uhr