Sony CDP-XE520: Additional Information Troubleshooting Specifications

Additional Information

Troubleshooting

Specifications

If you experience any of the following difficulties while

Compact disc player

using the player, use this troubleshooting guide to help

Laser Semiconductor laser (λ = 780 nm)

you remedy the problem. Should any problem persist,

Emission duration: continuous

consult your nearest Sony dealer.

Laser output Max 44.6 µW*

There’s no sound.

* This output is the value measured at

/ Check that the player is connected securely.

a distance of 200 mm from the

/ Make sure you operate the amplifier correctly.

objective lens surface on the Optical

/ Adjust the output level with LINE OUT LEVEL +/–

Pick-up block with 7 mm aperture.

on the remote (CDP-XE520 and CDP-XE320 only).

Frequency response 2 Hz to 20 kHz ± 0.5 dB

The CD does not play.

Signal-to-noise ratio More than 100 dB

/ There’s no CD inside the player. “- NO DISC -” (or

Dynamic range CDP-XE520: More than 98 dB

“no dISC” for the CDP-XE320 and CDP-XE220)

CDP-XE320 and CDP-XE220:

appears. Insert a CD.

More than 92 dB

/ Place the CD with the label side up on the disc tray

Harmonic distortion CDP-XE520: Less than 0.0045%

correctly.

CDP-XE320 and CDP-XE220:

/ Clean the CD (see page 17).

Less than 0.005%

/ Moisture has condensed inside the player. Remove

Channel separation More than 95 dB

the disc and leave the player turned on for about an

hour (see page 2).

Outputs

The recording level has changed (CDP-XE520 and

Jack

Maximum

Load

CDP-XE320 only).

type

output

impedance

/ The recording level changes if you adjust the output

level

level with LINE OUT LEVEL +/– on the remote

LINE OUT

Phono

2 V

Over 10 kilohms

during recording.

jacks

(at 50 kilohms)

The remote does not function (CDP-XE520 and CDP-XE320

DIGITAL

Optical

–18 dBm

Wave length: 660 nm

only).

OUT

output

/ Remove the obstacles in the path of the remote and

(OPTICAL)

connector

the player.

PHONES

Stereo

10 mW

32 ohms

/ Point the remote at the remote sensor g on the player.

(CDP-XE520

phone

/ Replace all the batteries in the remote with new ones

only)

jack

if they are weak.

General

Power requirements 220 V – 230 V AC, 50/60 Hz

Power consumption CDP-XE520: 11 W

CDP-XE320/XE220: 10 W

Dimensions (approx.) 430 × 95 × 290 mm

(w/h/d) (17 × 3 3/4 × 11 1/2 in.) incl. projecting

parts

Mass (approx.) CDP-XE520: 3.2 kg (7 lbs 1 oz)

CDP-XE320/XE220: 3.0 kg (6 lbs 10 oz)

Supplied accessories

Audio cord (2 phono plugs – 2 phono plugs) (1)

Remote commander (remote) (CDP-XE520 and

CDP-XE320 only) (1)

Sony SUM-3 (NS) batteries (CDP-XE520 and CDP-XE320

only) (2)

Design and specifications are subject to change without notice.

GB

18