Sony CPF-IP001: FAQ Troubleshooting Specifications

FAQ

Troubleshooting

Can I use the buttons on the main unit to

Should you encounter a problem with your system,

operate the iPod*?

find your problem in the troubleshooting checklist

You cannot use the buttons on the main unit to

below and take the indicated corrective action. If the

operate the iPod. Use the remote to operate the iPod.

problem persists, contact your Sony dealer.

Do I need to operate the iPod* to listen to

Note that if service personnel changes some parts

music?

during repair, these parts may be retained.

You can also use the remote to listen to music. For

When bringing the system in for repairs, be sure to

details about the operation of your iPod, refer to the

bring in the entire system.

user’s guide.

This product is a system product, and the entire system

is needed to determine the location requiring repair.

* See page 2 for compatible iPod models.

The ON indicator flashes.

• The system is in protect mode. Turn the subwoofer

off and on.

Specifications

There is no sound.

• Make sure the subwoofer is on.

Main unit

• Check the connections.

Continuous RMS power output (reference):

• Press VOLUME + on the main unit. If the volume is

5 W + 5 W

still low even after the system’s volume is turned up

(1 kHz, 10% THD)

to the maximum level, adjust the volume of the

Inputs

connected portable audio player (when using the

iPod (dock connector): See page 2 for compatible

LINE IN jack).

iPod models.

• Remove the protect case of the iPod*, and make sure

LINE: input mini jack (stereo)

the iPod is securely connected.

Speaker units: 28 mm dia.

• Make sure the iPod* is playing music.

Rated impedance (L/R): 8 Ω

• Check that the correct function is selected.

Dimensions (w/h/d): Approx. 206 × 58 × 91 mm

• When there is no sound from the subwoofer, turn the

Mass: Approx. 0.45 kg

subwoofer off, and then turn it on again.

Operating temperature: 10°C to 35°C

Power requirements: DC IN: 12 V, 1.0 A

The remote does not function.

• Remove any obstacles.

Subwoofer

• Point the remote at the main unit’s sensor.

Continuous RMS power output (reference):

15 W (100 Hz, 10% THD)

• Replace the battery.

Speaker units: 70 mm dia.

• Locate the system away from fluorescent lights.

Rated impedance (SW): 4 Ω

• Connect the iPod to the connector securely.

Dimensions (w/h/d): Approx. 218 × 74 ×

There is a severe hum or noise.

131 mm, incl. projecting

• Move the system away from the source of noise.

parts

• Connect the system to a different mains.

Mass: Approx. 1.3 kg

Operating temperature: 10°C to 35°C

The sound is distorted.

Power requirements: AC 220 V-240 V, 18 W,

• Press VOLUME – on the main unit to reduce the

50/60 Hz

volume.

(DC OUT: 12 V, 1.0 A)

• Set the sound mode of the iPod to off or flat sound

quality.

Design and specifications are subject to change

without notice.

GB

9