Sony SU-46HX1: Step 2: Installing the TV Step 1: Checking the parts 1 Hold the TV at the specified point when moving the TV.

Note on taking the TV Stand out from the carton

Step 2:

Be sure to hold the TV Stand and handle it carefully.

Installing the TV

Step 1:

Before assembling

• Be sure to have a Phillips screwdriver that fits the screws prior to

Checking the parts

the assembly.

• When using an electric screwdriver, set the torque setting to

approximately 1.5 N·m {15 kgf·cm}.

Name Quantity

Stand

1

Hold the TV at the specified point

when moving the TV.

1

1 Refer to the chart and measure lengths A and B

from the top edge of the TV, as shown in the

illustration below. Hold the TV at the specified

Rear Cover

point of the measured length B (x).

1

BABA

Neck Cover

1

TV Neck Attachment Screw

(PSW5 × 16) black (× 4)

5

Neck Cover Screw

(PSW5 × 16) black (× 1)

Unit: mm (inches)

TV size Length A Length B

WARNING

If you allow the AC power cord to be pinched under or between

52" 170 (6 3/4) 170 (6 3/4)

pieces of equipment, this may result in a short circuit or an electric

shock. If you stumble over the AC power cord or the connecting

46" 170 (6 3/4) 170 (6 3/4)

cable, the TV Stand may topple over and cause injury.

~

• Hold at the specified point to avoid injuring your fingers.

Decide on the installation location and lay the TV

Stand down before installing the TV.

2 Make sure to hold the TV as shown:

Since the TV is heavy, it is recommended that you decide on the

installation location beforehand, and assemble the TV Stand on

site.

Refer to the operating instructions supplied with your TV for

information on how to remove the Table-Top Stand from the TV.

~

• When transporting the TV set by hand, hold it as shown

above. Do not put stress on the LCD panel and the frame

around the screen.

4 (GB)