Sony CPF-NW001: FAQ Troubleshooting Specifications

FAQ

Troubleshooting

Can I use the buttons on the main unit to

Should you encounter a problem with your system,

operate the “Walkman”*?

find your problem in the troubleshooting checklist

You can adjust only the volume using the buttons

below and take the indicated corrective action. If the

on the main unit. Use the remote to operate the

problem persists, contact your Sony dealer.

“Walkman”.

Note that if service personnel changes some parts

Do I need to use the controls of the

during repair, these parts may be retained.

“Walkman”* to listen to music?

When bringing the system in for repairs, be sure to

You can also use the remote to operate the

bring in the entire system.

“Walkman.” For details about the operation of your

This product is a system product, and the entire system

“Walkman,” refer to the user’s guide.

is needed to determine the location requiring repair.

* See page 2 for compatible “Walkman” models.

The ON indicator flashes.

• The system is in protect mode. Turn the subwoofer

off and on.

Specifications

There is no sound.

• Make sure the subwoofer is on.

• Check the connections.

Main unit

• Press VOL +. If the volume is still low even after the

Continuous RMS power output (reference):

system’s volume is turned up to the maximum level,

5 W + 5 W

adjust the volume of the connected portable audio

(1 kHz, 10% THD)

player (When using the LINE IN jack).

Inputs

• Make sure the “Walkman”* is securely connected.

WM-PORT (22 pin): See page 2 for compatible

• Make sure the “Walkman”* is playing music.

“Walkman” models.

LINE: input mini jack (stereo)

• Check that the correct function is selected.

Speaker units: 28 mm dia.

• The subwoofer is in protect mode. Turn the

Dimensions (w/h/d): Approx. 206 × 53 × 88 mm

subwoofer off and on.

Mass: Approx. 0.45 kg

The remote does not function.

Operating temperature: 10°C to 35°C

• Remove any obstacles.

Power requirements: DC IN: 12 V, 1.0 A

• Point the remote at the main unit’s sensor.

Subwoofer

• Replace the battery.

Continuous RMS power output (reference):

• Locate the system away from fluorescent lights.

15 W (100 Hz, 10% THD)

There is a severe hum or noise.

Speaker units: 70 mm dia.

• Move the system away from the source of noise.

Dimensions (w/h/d): Approx. 218 × 74 ×

• Connect the system to a different mains.

131 mm, incl. projecting

parts

The sound is distorted.

Mass: Approx. 1.3 kg

• Press VOL – to reduce the volume.

Operating temperature: 10°C to 35°C

• Set the sound mode of the “Walkman”* to normal or

Power requirements: AC 220 V – 240 V,

flat sound quality.

18 W, 50/60 Hz

(DC OUT: 12 V, 1.0 A)

Design and specifications are subject to change

without notice.

GB

9