Sharp R-347H: INSTALLATION INSTRUCTIONS

A39566,Russia R347H O/M,EN

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity . Check the unit for any damage, such as a

misaligned door, damaged gaskets around the door or dents inside the oven cavity or on the door.

If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE

APPROVED BY SHARP and repaired, if necessary.

2. Accessories provided

1) Turntable tray

2) Roller stay

3) Operation manual

4) 2 Cook books

3. Locate the roller stay in the centre of the oven, then fit the turntable on the roller stay. Make sure the

turntable and roller stay are centrally located and locked together. NEVER OPERATE THE OVEN

WITHOUT THE ROLLER STAY AND TURNTABLE.

4. The oven should not be installed in any area where excessive heat and steam are generated, for

example, next to a conventional oven unit. The oven should be installed so as not to block ventilation

openings.

Allow at least 15 cm on the top of the oven for free air space.

5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or

personal injury for failure to observe the correct electrical connecting procedure.

The A.C. voltage must be single phase 220V, 50Hz.

6. THIS APPLIANCE MUST BE EARTHED.

OVEN DIAGRAM

62

C

9

7

3

8

A

1

B

0445

D

E

1. Door open button

8. Control panel (See page E-4)

2. Oven lamp

9. Digital readout

3. Door hinges

10. Waveguide cover (Do not remove)

4. Door safety latches

11. Turntable

5. See through door

12. Roller stay

6. Door seals and sealing surfaces

13. Ventilation openings

7. Coupling

14. Power supply cord

15. Rating label

E – 3

Russia R347H,En,P01-03 03.10.23, 4:33 PM3