Sharp R-340A: INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity. Check the unit for any damage, such as a

misaligned door, damaged gaskets around the door or dents inside the oven cavity or on the

door. If there is any damage, please do not operate the oven until it has been checked by a

SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.

2. Accessories provided

1) Turntable tray

2) Roller stay

3) Cook book (2)

4) Operation manual

3. Locate the roller stay in the centre of the

oven, then fit the turntable on the roller

stay.

Make sure the turntable and roller stay are

centrally located and locked together.

NEVER OPERATE THE OVEN WITHOUT

THE ROLLER STAY AND TURNTABLE.

Turntable

4. The oven should not be installed in any

area where excessive heat and steam are

generated, for example, next to a conven-

Roller Stay

tional oven unit.

The oven should be installed so as not to block ventillation openings.

Allow at least 15 cm on the top of the oven for free air space.

5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine

or personal injury for failure to observe the correct electrical connecting procedure.

The A.C. voltage must be single phase 220V, 50Hz.

OVEN DIAGRAM

1. Ventilation openings

8.Door open button

2. Oven lamp

9.Touch control panel

3. Door hinges

10.Digital readout

4. Door safety latches

11.Waveguide cover

5. See through door

12.Power supply cord

6. Door seals and sealing surfaces

13.Rating label

7. Coupling

E – 3