Sony SU-40NX1: Step 2: Installing the TV Step 1: Checking the parts 1 Hold the TV at the specified point when moving the TV.
Step 2: Installing the TV Step 1: Checking the parts 1 Hold the TV at the specified point when moving the TV.: Sony SU-40NX1
Table of contents
- On Safety WARNING CAUTION
- CAUTION
- Step 2: Installing the TV Step 1: Checking the parts 1 Hold the TV at the specified point when moving the TV.
- 2 Install the TV onto the TV Stand. 4 Attach the Bottom Cover to the TV set. 5 Secure the TV and the TV Stand with the Angle Adjustment Screw 3 Secure the TV and the TV Stand (PSW5 × 10) silver (supplied). with the four TV Neck
- 6 Attach the Neck Cover to the Step 3: Neck. Safety measures to prevent toppling over 7 Attach the Rear Cover to the TV Stand.
- Specifications Adjusting the viewing angle of the TV 1 2
- 3 4

Note on taking the TV Stand out from the carton
Step 2:
Be sure to hold the TV Stand and handle it carefully.
Installing the TV
Step 1:
Before assembling
• Be sure to have a Phillips screwdriver that fits the screws prior to
Checking the parts
the assembly.
• When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
Name Quantity
Stand
1
Hold the TV at the specified point
when moving the TV.
1
1 Refer to the chart and measure lengths A and B
from the top edge of the TV, as shown in the
illustration below. Hold the TV at the specified
Rear Cover
point of the measured length B (x).
1
BABA
Neck Cover
1
TV Neck Attachment Screw
(PSW5 × 16) black (× 4)
5
Neck Cover Screw
(PSW5 × 16) black (× 1)
Angle Adjustment Screw
1
Unit: mm (inches)
(PSW5 × 10) silver
TV size Length A Length B
TV Support Pad*
2
40" 110 (4 3/8) 170 (6 3/4)
* For KDL-40NX80s/KDL-46NX80s/KDL-52NX80s only.
46" 170 (6 3/4) 170 (6 3/4)
52" 170 (6 3/4) 170 (6 3/4)
WARNING
~
If you allow the AC power cord to be pinched under or between
• Hold at the specified point to avoid injuring your fingers.
pieces of equipment, this may result in a short circuit or an electric
shock. If you stumble over the AC power cord or the connecting
2 Make sure to hold the TV as shown:
cable, the TV Stand may topple over and cause injury.
Decide on the installation location and lay the TV
Stand down before installing the TV.
Since the TV is heavy, it is recommended that you decide on the
installation location beforehand, and assemble the TV Stand on
site.
Refer to the operating instructions supplied with your TV for
information on how to remove the Table-Top Stand and the
Bottom Cover (KDL-40NX80
s/KDL-46NX80s/KDL-
52NX80
s only) from the TV.
~
• When transporting the TV set by hand, hold it as shown
above. Do not put stress on the LCD panel and the frame
around the screen.
4 (GB)

