Sharp PN-E603: Turning Power On/Off

Turning Power On/Off

Caution

n

Mode setting

ENGLISH

• Turn on the monitor rst before turning on the PC or

When the monitor is turned on for the rst time after being shipped

playback device.

from the factory, the mode setting screen will be displayed.

(1)Press or to select YES or NO.

ENTER

(2)Press

Turning on the main power

YES:

• OPERATION MODE is set to MODE1.

• OFF IF NO OPERATION is set to ON, and STANDBY

MODE is set to LOW POWER. (These settings can not be

changed.)

• If there is no operation for 4 hours or more, the monitor

automatically enters standby mode.

• Compared to when set to STANDARD, the current

consumption is reduced while the monitor is in standby

mode/input signal waiting mode, but the startup/return time

from standby mode/input signal waiting mode becomes

longer.

Main power switch

• While the monitor is in standby mode, control via LAN will

be disabled.

• While the monitor is in standby mode/input signal waiting

mode, only certain RS-232C commands can be used.

• Depending on the input signal, the monitor may not switch

to input signal waiting mode and may not return from input

signal waiting mode.

Caution

NO:

• The main power must be turned on/off with the main power

• OPERATION MODE is set to MODE2.

switch. Do not connect/disconnect the power cord or turn

• OFF IF NO OPERATION is set to OFF, and STANDBY

the breaker on/off while the main power switch is on.

MODE is set to STANDARD. (These settings can be

• When switching the main power switch or the POWER

changed.)

button off and back on, always wait for at least 5 seconds.

• Compared to when set to LOW POWER, the startup/

return time from standby mode/input signal waiting mode

• For a complete electrical disconnection, pull out the main

is reduced, but more power will be consumed in standby

plug.

mode/input signal waiting mode.

Even after being set, changes can be made using

OPERATION MODE, located in MONITOR menu.

Turning power on/off

n

Date/time setting

Press the POWER button or POWER switch to turn the power

• If the time has yet to be set when the monitor is rst turned

ON/OFF.

on, the date/time setting screen appears. Set the date and

time.

DATE/TIME SETTING

//

Power switch Power LED

Status Status of the monitor

Green lit Power on

Orange lit Power off (Standby mode)

Green ashing Input signal waiting mode

Accessing the operation panel

7

E

: :

01 01 15

/

00 00

:/ 20

1. Press or to select the date and time, and

press

or to change the numerical values.

2. Press

.

• Be sure to set the date and time.

• The date/time setting screen will close automatically if

no operation is performed for about 15 seconds. The

date and time can be set using DATE/TIME SETTING

from the SETUP menu when the date/time setting screen

disappears.

TIPS

•

Set the date in “Day/Month/Year” order.

•

Set the time on a 24-hour basis.

•

The clock is maintained by the internal battery.

•

If you already set the time but the date/time setting

screen appears when the power is turned on, the

internal battery may be exhausted. Please contact an

authorized SHARP servicing dealer or service center for

assistance with battery replacement.

•

Estimated service life of the internal battery: About 5

years (depending on monitor operation)

•

The initial battery was inserted at the factory when the

monitor was shipped, so it may run out of power before

its expected operation life.