Fagor MG-35: 5. CLEANING AND MAINTENANCE

8

•

  To assemble the 2/3/6 accessories, line 

up the mark on the accessory with the 

one on the appliance and turn 30º in a 

clockwise direction 

(Fig. 2)

.

•

  Always clean the 2/3/6 accessories 

after use. To remove, turn anticlockwise 

and pull upwards. Clean with the brush 

supplied.

•

  Combs 4/5 must be assembled in 

accessory 3. These are assembled by 

lining up one side with the notch in 

accessory three, then pressing in until 

the other side goes into the other notch. 

(Fig. 3)

•

  When you have assembled the 

accessory, Push the ON/OFF switch 

upwards. The appliance will start 

operating and you can start cutting your 

hair. 

Cutting the hair in the ear

Assemble accessory 6 and then switch on 

the appliance. 

Move the accessory carefully around the 

parts of the ear with hair. 

Cutting nasal hair 

Assemble accessory 6 and then switch on 

the appliance.

Remove nasal hair by carefully making 

circular movements with the appliance.

Trimming sideburns or beard

Assemble accessory 2 and then switch on 

the appliance. Move the spacing comb to 

the length required (there are 5 positions). 

To do this, press the click and slide to the 

point required by pushing up or down 

(Fig. 4)

. If you like you can remove the 

spacing comb by pressing the clip and 

pressing upwards until it comes off; to 

assemble just slot it back into notches in 

attachment 2.

Move the accessory in an acute angle over 

the skin in a downward motion, without 

applying pressure. 

Do not move the unit in an upward or 

sideways direction. You may cut yourself.

Cutting hair on the neck and chest

Assemble accessory 3 and then switch on 

the appliance. If you prefer you can use 

combs 4 or 5. Remember that if the hair 

is too long it will cut with the sides of the 

accessory and if it is short it will cut with 

the central part. 

5. CLEANING AND MAINTENANCE

To clean the accessories, first remove from 

the appliance by turning anticlockwise and 

pulling upwards. Then use the cleaning 

brush supplied with the product.

After use, store the appliance and its 

accessories In the stand supplied. If 

the battery is not spent, do not plug the 

charger stand into the mains.

6. INFORMATION FOR THE CORRECT  DISPOSAL OF ELECTRICAL AND  ELECTRONIC APPLIANCES

At the end of its working 

life, the product must not 

be disposed of as urban 

waste. It must be taken to 

a special local authority 

differentiated waste 

collection centre or to a 

dealer providing this service. Disposing of 

a household appliance separately avoids 

possible negative consequences for the 

environment and health deriving from 

inappropriate disposal and enables the 

constituent materials to be recovered to 

obtain significant savings in energy and 

resources. 

To remind you that you must collaborate 

with a selective collection scheme, the 

symbol shown appears on the product 

warning you not to dispose of it in 

traditional refuse containers.

For further information, contact your local 

authority or the shop where you bought the 

product.