Braun ST780 Satin Hair 7: English
English: Braun ST780 Satin Hair 7
English
Our products are engineered to meet the highest standards
of quality, functionality and design. We hope you thoroughly
enjoy your new Braun appliance. Please read these use
instructions carefully before use and keep them for future
reference. For product videos, please go to www.braun.com.
Important
Plug your appliance into an alternating current outlet only and
make sure that your household voltage corresponds to the
voltage printed on the appliance.
This appliance must never be used near water
(e.g. a filled wash basin, bathtub or shower).
Do not allow the appliance to get wet. Always unplug
after use. Even when switched off the appliance presents a
hazard when near water.
Using the hot appliance on wet hair may cause hair damage.
Always dry your hair completely and evenly before using the
appliance. Do not use the appliance on permed hair.
Do not touch the hot styling plates (6) nor the active forming
area (5) of the appliance. When hot, do not place on surfaces
that are not heat-resistant.
For additional protection, it is advisable to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30 mA in the electrical circuit of your bathroom.
Ask your installer for advice.
Children as of 8 years and persons with reduced physical,
sensory or mental capabilities or lack of experience or
knowledge can use this appliance provided they have been
given supervision and instructions on its safe use and under-
stand the hazards involved. Children must not play with the
appliance. Children must not carry out cleaning and user
maintenance unless they are supervised.
Do not wrap the mains cord around the appliance. Do not
bend the anti-kink sleeve excessively during use or storage.
Regularly check the mains cord for wear or damage. If the
cord is damaged, stop using the appliance and take it to an
authorized Braun Service Centre. Unqualified repair work can
lead to extreme hazards for the user.
If the screen shows
, unplug the appliance and have it
repaired at a Braun Service Centre.
Description
1 Cool touch
2 Screen
3 Swivel cord with anti-kink sleeve
4 Control pad:
center button (on/off; confirm),
arrow buttons
5 Active forming area
6 Styling plates with integrated temperature sensors
Using the control pad
Connect the appliance to an electrical outlet. To switch on,
push the center button for at least 2 seconds. To move the
cursor on the screen, push the respective arrow.
To confirm your selection, press the center button .
To return to the previous screen, press t .
In order to prevent an unintended change of settings, the
control pad is provided with an automatic lock feature. When
the control pad is locked and you try to press any button, the
symbol appears on the screen. To unlock the control pad,
press the center button for at least 1 second.
Before first use
Select your language and the operation mode:
Using the q p arrows, select your language and confirm.
Select
and confirm.
ü
10
92064243_ST780_S6-104.indd 10 12.03.12 11:04
Next, select one of the operation modes: SensoCare or
Manual Mode, then confirm.
A SensoCare
In SensoCare mode, intelligent sensor technology enables
continuous temperature adaptation according to the specific
needs of your hair type. The styling temperature is not shown
on the display, but continuously optimized based on your hair
profile. This feature prevents hair damage caused by high
styling temperatures.
Set your profile / first use
To set your profile, go through the hair length, thickness and
coloration screens and select according to your hair type.
Confirm each setting with the center button and save your
settings by selecting a profile name (e.g. Profile 1). Confirm
and select «Continue» if you want to use your profile right
away.
The flashing thermometer symbol shows that the appliance
is heating up. Once the thermometer symbol stops flashing,
the optimum styling temperature is reached and you can start
styling.
Next use
Once a profile has been saved (e.g. Profile 1), the screen will
show it right after switching on the next time. Just confirm and
the appliance starts heating up.
Edit profiles
You can add new profiles or delete existing profiles. Up to
3 profiles can be saved.
You can modify your profile (e.g. if your hair length or colour
have changed).
Reset All
If you want to reset all settings (language and all profiles)
choose «Reset All» on the «Delete Profile» screen.
B Manual Mode
Manual Mode allows you to select the styling temperature.
This temperature will remain the same throughout the styling
process since the sensor-based automatic temperature
adaptation is deactivated in manual mode.
Move the cursor to «Manual Mode» and confirm. The default
temperature setting of 160 °C is displayed. Using the q p
arrows, you may change the temperature setting in a range
from 120 to 200 °C. While the appliance heats up, the temper-
ature screen flashes. When the flashing stops, the selected
temperature is reached and you can start styling.
Recommended temperature settings
Hair structure Coloured
hair
fine normal strong
120 °C - 150 °C 140 °C - 180 °C 170 °C - 200 °C up to 180 °C
C Using the appliance
Preparation
• Make sure your hair has been dried completely and evenly
before using the appliance.
• Comb your hair with a wide toothed comb to remove
tangles.
• Section your hair off. Starting close to the roots, take a thin
strand (2-3 cm maximum or 2 fingers wide) and clamp it
firmly between the styling plates.
How to straighten your hair
• Gently run the appliance through the entire length of the
hair, slowly and steadily, from roots to the ends without
stopping for longer than 2 seconds. This will ensure best
straightening results without damaging your hair. The styling
plates ensure easy and smooth gliding.
11
92064243_ST780_S6-104.indd 11 12.03.12 11:04
• For improved control when gliding along a strand, you may
stabilise the appliance by holding it with the other hand on
the cool touch points (1).
• You can create flicks at the hair ends by slowly turning the
appliance either outwards or inwards before releasing a
strand.
How to form loose curls and waves
– Clamp a thin strand at the roots,
– rotate the appliance half a turn so that the strand glides
through the styling plates and then over the active forming
area,
– then slowly move the appliance horizontally towards hair
tips. When pulling the appliance beyond the hair tips, the
strand will turn into curl.
Feedback
The SensoCare mode provides feedback on the
straightening performance after each stroke.
Speed (of stroke)
Right
Good, go on like this.
J
Fast
Move appliance more
Has the stroke been
K
slowly
performed slowly
enough?
Very Fast
Move appliance
L
slowly.
Moisture (level of
Dry
Good, go on like this.
J
hair)
Damp
You will get better
K
results on evenly dry
Is your hair evenly
Wet
hair.
dry?
L
In both SensoCare and Manual Mode, the screen
will show a hair dryer symbol if wet hair is detected
during styling. As a safety feature, the temperature
will decrease.
This means that you should dry your hair before straightening.
To deactivate the hair dryer symbol, push the center key.
After use
Turn off the appliance by pushing the center button for
2 seconds. The screen shows two options:
switch off
sleep mode
To switch off, select
12
Cancel...
and confirm with the center button.
The «cooling down» screen is shown provided the appliance
is still plugged in. When the temperature has dropped below
60 °C, the screen turns off and you can touch the appliance
without any risk.
Select if you want to resume styling later on. In sleep mode,
the temperature decreases to 100 °C. To quit sleep mode,
press any button. After 30 minutes in the sleep mode, the
appliance will switch off automatically.
Auto-shut-off
After 30 minutes of operation, the appliance switches
off automatically. The cooling down screen is shown as
long as the temperature is above 60 °C.
As long as the cooling down screen is shown, you can
resume styling: Press the center button and the previous
screen will be shown.
When the screen has turned off, you can touch the appliance
without any risk.
92064243_ST780_S6-104.indd 12 12.03.12 11:04
Cleaning
Always unplug before cleaning. Never immerse the appliance
in water.
Clean the appliance with a damp cloth and use a soft cloth to
dry.
Subject to change without notice.
Please do not dispose of the product in the household
waste at the end of its useful life. Disposal can take
place at a Braun Service Centre or at appropriate
collection points provided in your country.
Guarantee
We grant a 2 year guarantee on the product commencing
on the date of purchase. Within the guarantee period we will
eliminate any defects in the appliance resulting from faults in
materials or workmanship, free of charge either by repairing
or replacing the complete appliance at our discretion. This
guarantee extends to every country where this appliance is
supplied by Braun or its appointed distributor.
This guarantee does not cover: damage due to improper use,
normal wear or use as well as
defects that have a negligible effect on the value or operation
of the appliance. The guarantee becomes void if repairs are
undertaken by unauthorized persons and if original Braun
parts are not used.
To obtain service within the guarantee period, hand in or
send the complete appliance with your sales receipt to an
authorised Braun Customer Service Centre (address
information available online at www.service.braun.com).
For UK only:
This guarantee in no way affects your rights under statutory
law.
13
92064243_ST780_S6-104.indd 13 12.03.12 11:04
