Dell DX6000: Expansion Bus (continued) Memory Drives Connectors
Expansion Bus (continued) Memory Drives Connectors: Dell DX6000
Table of contents
- Getting Started With Your System
- Notes, Cautions, and Warnings
- Installation and Configuration Unpacking the System Installing the Rails and System in a Rack
- Optional—Connecting the Keyboard, Mouse, and Monitor Connecting the Power Cable(s)
- Securing the Power Cable(s) Turning On the System
- Installing the Optional Bezel Other Information You May Need
- Obtaining Technical Assistance NOM Information (Mexico Only) Technical Specifications Processor Expansion Bus
- Expansion Bus (continued) Memory Drives Connectors
- Connectors (continued) Video Power
- Power (continued) Physical Environmental
- Environmental (continued)

Expansion Bus (continued)
Riser 2 (Left Riser)
Two full-height, 9.5" length, x8 link (slot 3 and 4)
NOTE: Support for up to 25 W is available only on the first
two cards installed in the system; any additional cards
installed in the system must be 15 W or less.
Memory
Architecture 800, 1066, or 1333 MHz DDR3 registered or unbuffered
Error Correcting Code (ECC) DIMMs. Support for
Advanced ECC or Memory Optimized operation
Memory module
Eighteen 240-pin
sockets
Memory module
1 GB and 2 GB UDIMMs, and 2 GB, 4 GB,
capacities
or 8 GB RDIMMs
(single, dual, or quad-rank dependent on capacity)
Minimum RAM 1 GB with a single processor (1 DIMM)
Maximum RAM 96 GB (with quad-rank 8 GB RDIMM), 144 GB
(with dual-rank 8 GB RDIMM), or 24 GB (with 2 GB
UDIMMs)
Drives
Hard drives Up to six 3.5-inch, internal, hot-swappable SAS or SATA
hard drives
Diskette Drive Optional external USB 1.44 MB drive
Optical drive One internal slimline SATA DVD-ROM or
SATA DVD+RW drive
Optional external USB DVD
NOTE: DVD devices are data only.
Flash Drive Optional internal USB
Optional internal Secure Digital (SD) memory card
Optional external SD memory card
Connectors
Back
NIC
Four RJ-45 10/100/1000 Mbps Ethernet
10 Getting Started With Your System

