Beurer BY 77: 10. What if there are problems?

10. What if there are problems?

“Monitor” parent unit will not

Check whether

switch on.

•

the mains part plug is correctly connected,

•

the battery is correctly inserted,

•

the battery is full, needs charging or is damaged.

An acoustic signal sounds

Check whether

from the “monitor” parent unit.

•

the maximum range has been exceeded,

•

the mains part plug for the camera is correctly con-

nected,

•

the camera is switched on,

•

the parent unit’s battery needs charging.

The parent unit is switched on,

•

To set your desired volume on the parent unit, press

but is not making any noise.

the right or left arrow buttons during operation.

The “monitor” parent unit

•

Recharge the parent unit’s battery,

switches itself o.

•

It could be that the parent unit is in energy-saving

mode. Check whether the power-saving mode has

been selected in the menu and deactivate it where

necessary.

The signal is weak, the con-

•

If another technical device such as a microwave

nection keeps breaking up or

is in the area between the camera and the parent

there is interference.

unit, remove the technical device or switch it o.

•

Check whether other factors, such as trees or any-

thing else, are in the area between the camera and

the parent unit, and change the position of the de-

vices until the parent unit signals a connection.

•

Check whether the camera and parent unit are in-

side the maximum receiving range.

If no transmission is possible,

1. Switch on the camera and parent unit.

you have the option to retune

2. Delete the camera in the menu of the parent unit

the device signals digitally =

and then set up the camera again as described in

pairing.

the “Add camera” section.

25