Dell PowerEdge C1100: Connectors Video Power
Connectors Video Power: Dell PowerEdge C1100
Table of contents
- Notes, Cautions, and Warnings
- Installation and Configuration Unpacking the System Installing the Tooled Rail Solution
- 1 Install the sliding rails into the rack. 2
- 3 Installing the Tool-less Rail Solution
- 1 2 3
- 4 5
- 6 Optional – Connecting the Keyboard, Mouse, and Monitor
- Connecting the Power Cable(s) Securing the Power Cable(s)
- Turning On the System Complete the Operating System Setup
- Supported Operating Systems Other Information You May Need
- Technical Specifications Processor Expansion Bus Memory Drive
- Connectors Video Power
- Physical Environmental
- Environmental (continued)
Connectors
Back
NIC
Two RJ-45 (for integrated 10/100/1000 Mbps
Ethernet)
KVM over IP port
Dedicated Ethernet port for remote
management access
Serial
9-pin, DTE, 16550-compatible
USB
Two 4-pin, USB 2.0-compliant
Video
15-pin VGA
Front
USB (for 3.5-inch chassis only)
Two 4-pin, USB 2.0-compliant
Video
Video type AST2050 video controller; VGA connector
Video memory 8 MB
Power
AC power supply (redundant and non-redundant)
Wattage 650 W
Voltage
115–230 VAC, 50/60 Hz, 8/4 A
Heat dissipation
2217.8 BTU/hr maximum
Maximum inrush current
Under typical line conditions and over
the entire system ambient operating range,
the inrush current may reach 60 A per power
supply for 10 ms or less.
Batteries
System battery
CR 2032 3.0-V lithium coin cell
ROMB battery (optional)
3.7 V lithium ion battery pack
Getting Started With Your System 13
