Dell Latitude D631 (Early 2009): Starting the Dell Diagnostics From the Drivers and Utilities Media

The computer runs the Pre-boot System Assessment, a series of initial tests of your system board,

keyboard, hard drive, and display.

• During the assessment, answer any questions that appear.

• If a failure is detected, the computer stops and beeps. To stop the assessment and restart the

computer, press <Esc>; to continue to the next test, press <y>; to retest the component that

failed, press <r>.

• If failures are detected during the Pre-boot System Assessment, write down the error code(s) and

contact Dell (see "Contacting Dell" in your

User’s Guide

).

If the Pre-boot System Assessment completes successfully, you receive the message

Booting Dell

Diagnostic Utility Partition. Press any key to continue

.

5

Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.

Starting the Dell Diagnostics From the Drivers and Utilities Media

1

Insert the

Drivers and Utilities

media.

2

Shut down and restart the computer.

When the DELL logo appears, press <F12> immediately.

If you wait too long and the Windows logo appears, continue to wait until you see the Windows

desktop. Then shut down your computer and try again.

NOTE: The next steps change the boot sequence for one time only. On the next start-up, the computer boots

according to the devices specified in the system setup program.

3

When the boot device list appears, highlight

IDE CD-ROM DeviceCD/DVD/CD-RW Drive

and

press <Enter>.

4

Select the

Boot from CD-ROM

option from the menu that appears and press <Enter>.

5

Ty p e

1

to start the

ResourceCD

menu and press <Enter> to proceed.

6

Select

Run the 32 Bit Dell Diagnostics

from the numbered list. If multiple versions are listed, select

the version appropriate for your computer.

7

When the Dell Diagnostics

Main Menu

appears, select the test you want to run.

18 Quick Reference Guide