JVC KD-G827: Maintenance

Moisture condensation

Notice:

When operating an iPod or D. player,

Moisture may condense on the lens inside the

some operations may not be performed

CD player in the following cases:

correctly or as intended. In this case, visit the

• After starting the heater in the car.

following JVC web site:

• If it becomes very humid inside the car.

For iPod users:

Should this occur, the CD player may

ENGLISH

<http://www.jvc.co.jp/english/car/support/

malfunction. In this case, eject the disc and

ks-pd100/index.html>

leave the unit turned on for a few hours until

For D. player users:

the moisture evaporates.

<http://www.jvc.co.jp/english/car/support/

ks-pd500/index.html>

How to handle discs

When removing a disc from

Center holder

DAB tuner operations

its case, press down the center

• PTY Standby Reception works for the DAB

holder of the case and lift the disc

tuner only using a Dynamic PTY, but not a

out, holding it by the edges.

Static PTY.

• Always hold the disc by the

• TA Standby Reception for FM RDS station

edges. Do not touch its recording surface.

and Road Traffic News Standby Reception for

When storing a disc into its case, gently insert

DAB cannot be set separately. The T/P button

the disc around the center holder (with the

always work for the both Standby Reception

printed surface facing up).

modes when the DAB tuner is connected.

• Make sure to store discs into the cases after

• Only primary DAB services can be presetted

use.

even when you store a secondary service.

• A previously preset DAB service is erased

when a new DAB service is stored in the same

To keep discs clean

preset number.

A dirty disc may not play correctly.

If a disc does become dirty, wipe it

with a soft cloth in a straight line

from center to edge.

Maintenance

• Do not use any solvent (for example,

conventional record cleaner, spray, thinner,

How to clean the connectors

benzine, etc.) to clean discs.

Frequent detachment will deteriorate the

connectors.

To play new discs

To minimize this possibility, periodically wipe

New discs may have some rough

the connectors with a cotton swab or cloth

spots around the inner and outer

moistened with alcohol, being careful not to

edges. If such a disc is used, this

damage the connectors.

unit may reject the disc.

To remove these rough spots, rub the edges

with a pencil or ball-point pen, etc.

Connector

Do not use the following discs:

Sticker

Stick-on label

Sticker residue

Warped disc

39

EN36-43KD-G827[EE]f.indd 39EN36-43KD-G827[EE]f.indd 39 12/23/05 9:53:33 AM12/23/05 9:53:33 AM