Gorenje RC4180AW: Trouble-Shooting Guide

Trouble-Shooting Guide: Gorenje RC4180AW

Every now and then wipe the condenser on

the rear wall. Use soft non-metal brush or

vacuum cleaner.

Avoid using defrosting sprays, as they may

cause damage to the plastic parts and may

be hazardous to health.

Cleaning the Appliance

Do not forget to clean also the defrost water

receptacle above the refrigerator

Disconnect the power supply before

compressor (do not remove the receptacle).

cleaning the appliance.

Do not use coarse or aggressive cleaning

agents as you can damage the surface.

Be careful to remove any cleanser agent

remaining after cleaning.

Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft

cloth and an alcohol based cleaning agent

(for example glass cleaners). You may also

After cleaning, connect the appliance to power

use alcohol (ethanol or isoprophylic alcohol).

supply and reload the packages.

The application of abrasive and specially

aggressive cleaners, such as the stainless

Switch Off the Appliance When Not In

steel cleaners, is not appropriate for the

cleaning of plastic and coated parts.

Use

Remove the detachable accesories in the

If you do not intend to use the appliance for a

interior of the appliance and clean it with

longer period, set the thermostat knob to the

water and liquid detergent. Plastic parts

STOP (0) position, disconnect the power supply,

cannot be washed in washing machine.

take out the foods and defrost and clean the

Wash the interior of the appliance with

appliance. Leave the door slightly open.

lukewarm water, in which you added one or

two spoonfuls of vinegar.

Trouble-Shooting Guide

During the service, you can come across some

The door is not properly closed (the door

troubles that in most cases result from

may sag, the gasket may be polluted or

improper handling of the appliance and can

damaged).

easy be eliminated.

Perhaps you have overloaded the appliance

with fresh foods.

The Appliance Fails to Operate After

The reason may be inadequate ventilation of

connecting to the Mains Supply

the compressor and condenser (assure

Check the supply in the outlet socket and

adequate air circulation and wipe off the

make sure the appliance is switched on

condenser).

(thermostat in operating position).

Continuous operation button activated (see

section Freezing of Food).

Continuous Operation of the Refrigerating

System

Ice Formation on the Inner Rear Wall

The door was frequently opened or it was left

As long as the defrost water runs to the

opened for too long.

channel and through the opening to the drain

Instructions for Use12

pan on the compressor, automatic defrosting of

it has no influence whatsoever on the

the appliance is assured.

lifetime of the appliance.

In case the ice formation on the inner back wall

After starting the appliance, the operation

is increased (3-5 mm), ice should be manually

of the compressor and the refrigerant flow

defrosted.

may be louder, which does not mean that

Set the thermostat knob to STOP (0) position

something is wrong with the appliance and it

and leave the door open. Never use electric

has no influence on the lifetime of the

devices for defrosting and do not scrape the

appliance. Gradually the noise is reduced.

ice or frost layer with sharp objects.

Sometimes unusual and stronger noise is

After completed defrosting, turn the knob to

heard, which is rather unusual for the

desired position and close the refrigerator door.

appliance. This noise is often a

The cause of increased ice formation may be

consequence of inadequate placing.

one of the following:

The appliance shall be placed and

the door does not seal well (clean the

levelled firmly on solid base.

gasket if it is contaminated, or replace it

It should not touch the wall or kitchen

if it is damaged);

units standing next to it.

the door was frequently opened or it was

Check the accesories in the interior of

left opened for too long;

the appliance, they should be placed

the food stored in the refrigerator was warm;

correctly in their positions; also check

the food or dish is touching the inner

the bottles, tins and other vessels that

back wall

might touch each other and rattle.

Water is Leaking From the Refrigerator

Bulb Replacement

In case the discharge water outlet is clogged,

Before replacing the light bulb, disconnect the

or the defrost water drips over the channel,

appliance form the power supply.

water leaks from the refrigerator.

Press the cover at the rear side (in the arrow 1

Clean the clogged opening, for example with

direction) and remove the plastic cover (in the

a plastic straw.

arrow 2 direction). Replace the bulb with a new

Manually defrost the increased ice layer.

one (E14, max. 15 W).

See "Ice Formation on the Inner Back Wall".

Don't forget: the old bulb does not belong to

organic waste.

The Freezer Door is Hard to Open

Light bulb is consuming good therefore our

If you want to open the door that has just or

in-guarantee service does not relate to it.

recently been closed, you may find it hard to

open. The reason why this happens is, that

when you open the door, warm air gets into the

appliance and when it is getting cool, the

underpressure seals the door. After few

minutes (5-10), the door can easily be opened.

Noise

Cooling in refrigerating-freezing appliances is

enabled by the refrigerating system with

compressor, which produces noise. How noisy

the appliance is depends on where it is placed,

how it is used and how old the appliance is.

During the operation of the compressor the

noise of liquid is heard and when the

compressor is not operating, the refrigerant

flow is heard. This is a normal condition and

WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE

ON THE OPERATION OF THE APPLIANCE.

Instructions for Use 13