Gorenje RC4180AW: Placing and Installation

Time During Power Supply

Disposing of the Worn Out Appliance

Interruption

• When your appliance finally wears out,

Do not open the freezer in case of failure or

dispose it of. If the appliance has a lock,

power supply interruption! In case the

break it, in order to prevent eventual

interruption is extended over longer period of

accidents (danger of children get locked

time (13 hours for HZDS 2121/6, 14 hours for

inside the appliance).

HZDS 2621/6 and 15 hours for HZDS 2521/6),

• The refrigerating system of the appliance is

take food out of the freezer and use it, or make

filled with refrigerant and insulating

sure that is sufficiently cooled (perhaps you

substances which should be separately

have an extra appliance).

treated and processed. Call your nearest

authorised service agent or specialised

servicing centre. If you don't find one, contact

your local authorities or your distributor. Be

careful not to damage the tubes on the rear

wall of the appliance (danger of pollution).

Placing and Installation

Choosing the Right Place

Place the appliance in a dry and regulariy

ventilated room. Allowed ambient temperature

depends on the model (class) of the appliance

and is stated on the rating plate of the

appliance.

Never place the appliance near heat emitting

devices (e.g. cooker, radiator, water heater or

• The appliance with ventilation grid may be

similar devices) and do not expose it to direct

placed close to the wall. The grid enables

sunlight.

sufficient air circulation, required for

The appliance should be positioned at least 3

adequate ventilation of the rear wall.

cm away from the electric or gas cooker and at

least 30 cm away from the oil or coal stove. If

this is not possible, use an appropriate

insulation.

Behind the appliance there should be free

space at least 200 cm² wide and above the

appliance the high kitchen units should be at

least 5 cm away from the appliance in order to

assure adequate ventilation of the condenser

unit.

• Two spacers attached to the appliance must

Class Ambient temparature

be fitted onto the upper edge of the

SN (sub-normal) from + 10°C to + 32°C

condenser, thus preventing the appliance

N (normal) from + 16°C to + 32°C

from being installed too close to the wall.

ST (sub-tropical) from + 16°C to + 38°C

Spacers are manufactured for all-purpose

T (tropical) from + 16°C to + 43°C

function depending on the distance of the

condenser from the wall. Therefore turn

spacers correspondingly and fix them to the

Placing the Appliance

appliance.

• Place the appliance firmly on a solid base.

Some appliances have adjustable feet on

the front side; use them to level the

appliance.

Instructions for Use4