Beurer BM 60: Deleting saved values 6. Calling up stored values 7. Cleaning and storing the instrument

If the following measurement shows a lack of stability again,

•

If you press the memory buttons again, further individual

repeat the measurement after another period of rest. In case of

measurements appear with WHO, cardiac arrythmia and

further unstable measurements, identify these measurements

HSD. These individual values are numbered from 1 to 60. The

as they were taken when the circulatory system had not be suf-

time and date are alternately displayed after 2.5 seconds.

ficiently rested.

•

If there are 60 individual values in the memory at the same

In this case, inner unrest of the nervous system could be the

time, the oldest value is deleted in order to make room for

cause, which cannot be cured by brief periods of rest. Devel-

the new value.

oping cardiac arrhythmia can also prevent stable blood pres-

•

Use the start/stop button to turn off the device, or it will

sure measurements.

turn off automatically after approx. 30 seconds.

A lack of resting blood pressure can have various causes, such

Tip: You can also use the 2 user memories to separately store

as physical or mental strain or distraction and speaking or expe-

measurements – e.g. mornings and evenings.

riencing heart rhythmic disturbance during the measurement.

Deleting saved values

In an overwhelming number of cases, the HSD diagnosis will

You can delete saved values individually or else you can delete

give a very good guide as to whether the circulatory system is

all of them.

rested when taking the measurement. Certain patients suffering

•

To delete individual values, first select the stored value

from cardiac arrhythmia or chronic mental conditions can remain

you wish to delete and keep memory button M1 or M2

haemodynamically unstable in the long-term, something which

depressed. The display starts blinking. Keep holding the but-

persists even after repeated periods of rest. The precision of the

ton depressed until the display has completely cleared.

results of the resting blood pressure is reduced in these users.

•

To delete an entire user memory, you have to select the

Like any medical measurement method, the precision of the HSD

appropriate user memory. The average is displayed and indi-

diagnosis is limited and can lead to incorrect results in some

cated with . Hold the memory button M1 or M2 depressed

cases. The blood pressure measurements taken when the circu-

until the display starts blinking and keep the button

latory system was at rest represent particularly reliable results.

depressed until the display completely clears.

6. Calling up stored values

7. Cleaning and storing the instrument

You can call up values from the 2 user memories and display the

•

Clean your device and cuff carefully only with a slightly mois-

averages.

tened cloth.

•

Press the M1 or M2 memory buttons. Firstly, the average of

•

The frequency of cleaning depends on the contamination

all values stored in this user memory will be displayed. This

level of the device. Clean the blood pressure device and cuff

is denoted by the letter in the display.

as soon as any dirt appears on the device.

22