Beurer BC 32: 4. Prepare measurement 5. Measuring blood pressure
4. Prepare measurement 5. Measuring blood pressure: Beurer BC 32
Table of contents
- 2. Important information 1. Getting to know your instrument
- Advice on use
- Storage and Care Repair and disposal Advice on batteries
- 3. Unit description
- 4. Prepare measurement 5. Measuring blood pressure
- Evaluating results
- Range of blood pressure values Systolic (in mmHg) Diastolic (in mmHg) Measure 6. Saving, retrieving and deleting results 7. Error messages / troubleshooting
- 8. Cleaning and Care 9. Technical details
- This unit is in line with European Standard EN 60601-1-2

4. Prepare measurement
•
Set the day, hour and minute and confirm in each case with
the function key .
Inserting battery
•
Confirm your selection with the function key .
•
Remove the battery
cover (left side of the
5. Measuring blood pressure
unit).
Positioning cuff
•
Insert two 1.5 V micro
batteries (alkaline, type LR 03). Make absolutely sure that
you insert the batteries with the correct polarity as marked.
Do not use rechargeable batteries.
•
Replace the battery cover carefully.
If the ’change battery’ icon
is displayed, measurement is
no longer possible and you must replace all the batteries. Used
batteries do not belong in the household waste. You are legally
•
Bare your left wrist, making sure that the circulation in the
obliged to dispose of the batteries. Dispose of them via your
arm is not restricted by any clothes etc. that are too tight.
specialist electrical supplier or local collec ting point for recy-
Position the cuff on the inside of your wrist.
clable waste.
•
Fasten the cuff with the Velcro fastening so that the upper
Note: You will find these markings on batteries
edge of the monitor is positioned approx. 1 cm below the
containing harmful substances: Pb = battery
ball of your thumb.
containing lead, Cd = battery containing cad-
•
The cuff has to be fitted tightly around the wrist but should
mium, Hg = battery containing mercury.
not constrict it.
Setting date and time
Correct posture
It is vital to set the date and time. This is the only way that
•
Rest for approx. 5 minutes before each measurement. Other-
measurements can be saved and recalled with the correct date
wise there may be divergences.
and time.
•
You can perform the measurement
Proceed as follows to set the date and time:
while sitting or lying. To carry out a
• Switch on the blood pressure monitor with the button.
blood pressure measurement, make
•
Press the function key for over 5 seconds
sure you are sitting comfortably with
•
The month starts flashing. Using the + function key, set the
your arms and back leaning on some-
month 1 to 12 and confirm with the function key
thing. Do not cross your legs. Place
15
Pb Cd Hg

