Hotpoint-Ariston AVTL 104: Personalisations

Personalisations: Hotpoint-Ariston AVTL 104

Personalisations

Setting the temperature

GB

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).

The temperature can be lowered, or even set to a cold wash (

).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.

The maximum spin speeds for each programme are as follows:

Programmes Maximum spin speed

Cottone 1000 rpm

Synthetics 800 rpm

Wool 600 rpm

Silk no

The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol

.

The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for

each programme.

To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by

continuously rotating the drum at a speed which is slightly faster than the normal washing speed.

When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than

the set frequency.

If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.

The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:

1. press the button corresponding to the desired function, according to the table below;

2. the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the

programme set.

Function Effect Comments Enabled with

programmes:

Super

Allows for an

Wash

impeccable

wash, visibly

1, 2, 3, 4,

This function is incompatible with the RAPID function.

whiter than a

5, 6, 7, 8

standard

Class A wash.

Easy i r on This option

When this function is set, programmes 6, 7, 8, 11 and

All

reduces the

Delicate rinse will end with the laundry left to soak

programmes

amount of

(Anti-crease) and the Rinse cycle phase LED will

except for

creasing on

flash.

1, 2, 9, 10

fabrics,

- to conclude the cycle, press the START/RESET

and

making them

button;

Draining.

easier to iron.

- to run the draining cycle alone, set the knob to the

relative symbol and press the START/RESET

button.

Rapid Cuts the

1, 2, 3, 4,

duration of

This function is incompatible with the SUPER WASH

5, 6, 7, 8

the wash

function.

Rinses

cycle by 30%.

Extra

Increases the

Recommended when the appliance has a full load or

1, 2, 3, 4, 5,

Rinse

efficiency of

with large quantities of detergent.

6, 7, 8, and

the rinse.

Rinse

cycles.

7

Оглавление