Hotpoint-Ariston AVTL 83: инструкция

Instructions for use

WASHING MACHINE

Contents

GB

GB

Installation, 2-3

GB

ES

F

CIS

Unpacking and levelling, 2

Electric and water connections, 2-3

English, 1

Français, 13

ÐÓÑÑÊÈÉ, 25

The first wash cycle, 3

Technical details, 3

Washing machine description, 4-5

ES

ES

IT

GR

Control panel, 4

How to open and shut the drum, 5

Español, 37

Italiano, 49

ÅËËÇÍÉÊÁ, 61

Leds, 5

Starting and Programmes, 6

Briefly: how to start a programme, 6

Programme table, 6

Personalisations, 7

Setting the temperature, 7

Setting the spin cycle, 7

Functions, 7

Detergents and laundry, 8

Detergent dispenser, 8

Bleach cycle, 8

Preparing your laundry, 8

Special items, 8

AVTL 83

Woolmark Platinum Care, 8

Precautions and advice, 9

General safety, 9

Disposal, 9

Saving energy and respecting the environment, 9

Care and maintenance, 10

Cutting off the water or electricity supply, 10

Cleaning your appliance, 10

Caring for your appliance door and drum, 10

Cleaning the pump, 10

Checking the water inlet hose, 10

Cleaning the detergent dispenser, 10

Troubleshooting, 11

Service, 12

Before calling for Assistance, 12

1

Installation

 Keep this instruction manual in a safe place for

loosening the adjustable front feet (see figure); the

GB

future reference. Should the appliance be sold,

angle of inclination, measured according to the

transferred or moved, make sure the instruction

worktop, must not exceed 2°.

manual accompanies the washing machine to inform

Levelling your appliance correctly will provide it with

the new owner as to its operation and features.

stability and avoid any vibrations, noise and shifting

during operation. If it is placed on a fitted or loose

 Read these instructions carefully: they contain vital

carpet, adjust the feet in such a way as to allow

information on installation, use and safety.

enough room for ventilation beneath the washing

machine.

Unpacking and levelling

Unpacking

Electric and water connections

1. Unpack the washing

machine.

2. Check whether the

Connecting the water inlet hose

washing machine has

been damaged during

1. Insert seal A into the

transport. If this is the

end of the inlet hose and

case, do not install it

screw the latter onto a

and contact your

cold water tap with a 3/4

retailer.

gas threaded mouth (see

A

figure).

3. Remove the four

Before making the

protective screws and

connection, allow the

the rubber washer with

water to run freely until it

the respective spacer,

is perfectly clear.

situated on the rear of

the appliance (see

2. Connect the other end

figure).

of the water inlet hose to

4. Seal the gaps using the plastic plugs provided.

the washing machine,

5. Keep all the parts: you will need them again if the

screwing it onto the

washing machine needs to be moved to another

appliance's cold water

location.

inlet, situated on the top

right-hand side on the rear

Warning: should the screws be re-used, make sure

of the appliance

you fasten the shorter ones at the top.

(see figure).

 Packaging materials are not children's toys.

3. Make sure there are no kinks or bends in the

hose.

Levelling

Your machine may make a considerable amount of

 The water pressure at the tap must be within the

noise if the two front feet have not been adjusted

values indicated in the Technical details table

correctly.

(on the next page).

1. Install the washing

machine on a flat sturdy

 If the water inlet hose is not long enough, contact

floor, without resting it

a specialist store or an authorised serviceman.

up against walls,

furniture cabinets or

other.

2. If the floor is not

perfectly level, compen-

sate for any unevenness

by tightening or

2

outdoor environment, not even when the area is

GB

sheltered, because it may be very dangerous to

leave it exposed to rain and thunderstorms.

Connecting the drain

hose

 When the washing machine is installed, the main

Connect the drain hose,

socket must be within easy reach.

65 - 100 cm

without bending it, to a

draining duct or a wall

 Do not use extensions or multiple sockets.

drain situated between

65 and 100 cm from the

 The power supply cable must never be bent or

floor;

dangerously compressed.

 The power supply cable must only be replaced by

an authorised serviceman.

Warning! The company denies all liability if and when

these norms are not respected.

alternatively, place it

over the edge of a

The first wash cycle

basin, sink or tub,

fastening the duct

Once the appliance has been installed, and before

supplied to the tap (see

you use it for the first time, run a wash cycle with

figure). The free end of

detergent and no laundry, setting the 90°C

the hose should not be

programme without a pre-wash cycle.

underwater.

Technical details

 We advise against the use of hose extensions; in

case of absolute need, the extension must have the

Model

AVTL 83

same diameter as the original hose and must not

40 cm wide

exceed 150 cm in length.

Dimensions

85 cm high

60 cm deep

Capacity

from 1 to 5 kg

Electric connection

Electric

Please refer to the technical data plate

connections

fixed to the machine.

Before plugging the appliance into the mains socket,

make sure that:

maximum pressure 1 MPa (10 bar)

Water

 the socket is earthed and in compliance with the

minimum pressure 0.05 MPa (0.5 bar)

connections

applicable law;

drum capacity 42 litres

Spin speed

up to 800 rpm

 the socket is able to sustain the appliance's

maximum power load indicated in the Technical

Control

details table (on the right);

programmes

programme 3; temperature 60°C;

according to EN

run with a load of 5 kg.

 the supply voltage is included within the values i

60456 directive

ndicated on the Technical details table

This appliance is compliant with the

(on the right);

following European Community

Directives:

 the socket is compatible with the washing

- 89/336/CEE of 03/05/89

machine's plug. If this is not the case, replace the

(Electromagnetic Compatibility) and

subsequent amendments

socket or the plug.

- 2006/95/CE (Low voltage)

- 2002/96/CE

 The washing machine should not be installed in an

3