Beurer BC 50: 8. Error messages/troubleshooting 7. Transferring measurements 9. Cleaning and maintenance

•

Start individual measurement access.

8. Error messages/troubleshooting

•

Press and hold the M1 & M2 memory buttons for 5 sec-

In the event of errors, the error message

E

_

appears on the

onds.

display.

Error messages may appear if:

CL

and

00

appear on the display.

•

It was not possible to record the pulse:

E 1

;

All the values in the current user memory

•

You move or speak during the measurement::

E2

;

are deleted.

•

The cuff is fastened too tightly or loosely:

E3

;

The device will then switch off automati-

•

Errors occur during the measurement:

E4

;

cally.

•

The pump pressure is higher than 300 mmHg:

E5

;

•

The batteries are almost empty

E6

.

In such cases, repeat the measurement. Ensure that you

7. Transferring measurements

do not move or speak. If necessary, reinsert or replace the

Connect the blood pressure monitor to your PC using the

batteries.

USB cable.

No data transfer may be launched whilst performing a

9. Cleaning and maintenance

measurement.

•

Clean your blood pressure monitor carefully using a slightly

damp cloth only.

PC

is shown on the display. Begin the data

•

Do not use any cleaning agents or solvents.

transfer in the “HealthManager” PC software.

•

Under no circumstances should you hold the unit under

During the data transfer, an animation is

water, as this can cause liquid to enter and damage the

shown on the display. A successful data

unit.

transfer is displayed as in figure 1. If the data

•

Never place any heavy objects on the device.

transfer is unsuccessful, an error message

f

igure 1

appears as in figure 2. In this case, interrupt

the PC connection and start the data transfer

again.

After 30 seconds of not being in use or if

communication with the PC is interrupted,

f

igure 2

the blood pressure monitor switches itself off

automatically.

23